Table of Contents
Advertisement
Assembly—ROCK & TONE
5. Attach a Rear
Stabilizer (8) to the
Base (2) with two
M8 x 63mm
Carriage Bolts (31)
and two M8 Nylon
Locknuts (34).
6. Attach a Front
Stabilizer (9) to the
Adjustment Frame
(3) with two M8 x
63mm Carriage
Bolts (31) and two
M8 Nylon Locknuts
(34).
Press the 30mm
Square Inner Cap (17) into the Adjustment Frame (3)
and secure it with the M4 x 12mm Screw (39). Slide
the Adjustment Frame through the Slider Bushing (27)
and into the Base (2). Insert the Adjustment Pin (26)
into the indicated hole in the Base and a hole in the
Adjustment Frame.
Attach the Press Plate (6) to the Adjustment Frame (3)
with two M8 x 43mm Carriage Bolts (32), two M8
Washers (35), and two M8 Nylon Locknuts (34).
7. Make sure the End
Plate (19) is inside
the Angled Cap
(18). Press the
Angled Cap onto
the bottom end of
the Backrest
Frame (1). Press a
38mm Square
Inner Cap (24) into
the top of the
Backrest Frame.
Attach the Pivot
Frame (7) to the
Backrest Frame (1)
with two M8 x
52mm Button Bolts
(42), two M8 Washers (35), and two M8 Nylon
Locknuts (34).
Attach the Pivot Frame (7) to the Base (2) with an M10
x 64mm Bolt (37) and an M10 Nylon Locknut (36). Do
not over tighten the Locknut; the Pivot Frame must
be able to pivot easily.
5
31
8
34
2
6
32
39
2
3
26 27
17
34
9
7
24
1
34
35
7
34
35
36
2
37
8. Slide a Grip (22)
onto each end of the
Handlebar (21).
34
Attach the
Handlebar (21) to
the Backrest Frame
(1) with two M8 x
52mm Button Bolts
(42), two M8
Washers (35), and
6
two M8 Nylon
Locknuts (34).
35
Attach the Small Seat (29) to the Handlebar (21) with
two M6 x 42mm Button Screws (46) and two M6
34
Washers (38).
31
9. Insert an M6 x
50mm Carriage Bolt
(45) into the center
hole of the Support
Plate (20).
Attach the Support
Plate (20) to the
Backrest (4) with
two M6 x 16mm
Button Screws (40).
Attach the Backrest (4) to the Backrest Frame (1) with
the M6 x 50mm Carriage Bolt (45), an M6 Washer
(38), and an M6 Nylon Locknut (44).
Secure the Backrest (4) with an M6 x 55mm Button
Screw (43) and an M6 Washer (38).
The use of the remaining parts will be explained in
Adjusting The Body Toning System.
42
19
18
8
29
1
35
46 38
22
38
34
35
9
38
43
1
4
38
20
40
44
45
22
21
42
42
Advertisement
Table of Contents
