Editing Program - American DJ Accu Roller 250 User Instruction

Accu Roller 250™
EDIT
- This feature allows you to write and store a preset
show into the fixtures internal memory (EEPROM) via the con-
trol panel or via the external controller. This show can then be
recalled at anytime without a controller.
RUN
- With this function you can run your pre-made pro-
gram. You can set the number of steps under "STEP", and
you can edit the individual scenes under "EDIT".
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed, press ENTER.
3. Tap the UP button until "RUN" is displayed, press ENTER.
4. Press the UP button to display "ON" to activate this function,
or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
STEP
- With this function you can define the number of
steps in the Run Program.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed, press ENTER.
3. Tap the UP button until "STEP" is displayed, press ENTER.
4. The display shows "S-01", "01" stands for the first step of
your program. You can call up to 48 scenes in "Run". For exam-
ple, if "S-05" is displayed, it means that "Run" will run the first 5
scenes you saved in "Edit".
5. Press ENTER to save and MODE/ESC to exit.
American DJ - www.americandj.com - Accu Roller 250™ Instruction Manual Page 29
®

Editing Program

Accu Roller 250™
Editing procedure 1: Using the control board only.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed. Press ENTER.
3. The display will show "SC01", this stands for the scene
number. For example, "SC01" is displayed, it means you will
be editing scene 1, press ENTER. You can change the scene
number by pressing the UP button.
4. Press ENTER, the display will show "C-1", this stands for the
channel number. If "C-01" is displayed, you will be editing chan-
nel 1 of your selected scene, press ENTER. You can change the
scene number by pressing the UP button.
5. The display will show the DMX value for the channel that is
being edited. It will be displayed as "11XX", it stands for Channel
11 of the editing scene, the DMX value is "XX".
6. Adjust the DMX value by pressing the UP button, until you
get the expected effect for this channel.
7. Press ENTER to enter the editing of the other channels of the
scene.
8. Repeat steps 5-8, until you finish setting all the DMX values
for all the channels of this scene, each scene can have 15
channels maximum.
9. Once all the channels are completed, the display will flash
"TIME", this stands for the time needed to run this scene.
10. Press ENTER to edit the time needed, the display shows
"T-XX", "XX" stands for the time needed to run this scene. For
example, "T-02" means scene 1 needs 6 seconds to run, "T-15"
means scene 5 needs 45 seconds to run.
11. Adjust the time needed by pressing the UP button.
12. Press ENTER to save the settings for the scene you are
American DJ - www.americandj.com - Accu Roller 250™ Instruction Manual Page 30
®
Editing Program