Care And Cleaning - Vicks V3100 Use And Care Manual

Filtered cool moisture
Hide thumbs Also See for V3100:
Table of Contents

Advertisement

Available languages

Available languages

Care and Cleaning

CAUTION:
ALWAYS TURN OFF THE POWER SWITCH AND DISCONNECT THE POWER
CORD FROM THE ELECTRICAL OUTLET BEFORE CLEANING.
Humidifiers provide comfort by adding moisture to dry indoor air. For maximized benefit from
your Vicks Cool Mist Humidifier, follow instructions carefully. Please note that this is an
electric appliance and requires careful attention when in use.
Tap water may contain pollutants and minerals (scale) that can deposit on the inner surfaces of
the Humidifier and clog the Wicking Filter. Such scale can accelerate the growth of
microorganisms and can impair the performance of the Wicking Filter.
daily maintenance
1.
Turn switch to OFF position and unplug the cord from wall outlet.
2.
Lift the Water Tank from Base. Carefully remove the Water Tray from the base being
careful not to damage the delicate Wicking Filter. Empty excess water from the Water Tray
without removing the Wicking Filter. Remove the Tank Cap and drain any water from the
Water Tank. Rinse the Water Tank with lukewarm water after each use. Wipe accessible
surfaces of the Water Tank and Water Tray clean with a soft, damp cloth.
3.
do not immerse the Base in water. For storage, wipe dry with a soft, clean cloth. Keep
water away from the Air Outlet.
4.
do not leave water in the Water Tank or Water Tray when unit is not in use as it may
result in the build up of mineral deposits and bacteria that can inhibit the output efficiency
of the humidifier. Please note that if water remains in the Water Tank for more than a day
or two, bacterial growth is possible.
5.
Replace Water Tray with Wicking Filter. Then replace the Tank. Humidifier is now ready for
use.
Weekly maintenance
Removing scale
1.
Remove the Water Tank and empty any remaining water from the Water Tank.
2.
Turn switch to the ON position, either low or high speed, and operate Humidifier until the
Wicking Filter is thoroughly dry.
3.
Turn switch to the OFF position and unplug the cord from wall outlet.
4.
Remove Wicking Filter from the Water Tray by carefully lifting straight up taking care not to
tear filter.
5.
Remove the Water Tray from the Base. Fill Water Tray with undiluted white vinegar. Let
stand for 20 minutes.
6.
Dampen soft, clean cloth or sponge with undiluted white vinegar and wipe out Water Tray
to remove scale. do not use soap, detergents or abrasive cleaners.
7.
Rinse the Water Tray thoroughly in clean warm water or put in top shelf of dishwasher to
remove scale and vinegar before disinfecting the Water Tray.
6
disinfecting the Water tray and tank
1.
Fill tank with 1 teaspoon of household bleach in 1 gallon of water. Let stand twenty (20)
minutes, shaking vigorously every few minutes, drain and rinse with clean water until the
bleach smell is gone. Dry with a clean cloth or paper towel.
2.
Wipe the Water Tray with a soft cloth dampened in the bleach and water solution. Rinse
the Water Tray thoroughly or place in dishwasher before proceeding.
3.
Wipe all exterior surfaces of the Base with a soft, dry cloth. Do not immerse the Base in
water or use water to clean the base. An electric shock may result or the humidifier may
be damaged.
caution: do not wash the Wicking Filter since this could damage the wick.
end of season maintenance
1.
Follow above weekly cleaning procedure at the end of the humidification season, or when
the humidifier will not be used for several days, being sure to dry all parts. Allow the Water
Tank to air dry before storing. Do not store with water inside.
2.
Leave Tank Cap partially loosened during storage to prevent Tank Cap and Gasket from
sticking together. This will prolong the life of the gasket.
3.
At the end of season, remove and throw away the Wicking Filter. Never leave a used filter
in the humidifier during storage.
4.
Store in a cool dry location.
5.
Order your new Kaz Replacement WF2 Wicking Filter now, so that it will be available for
use next season.
Wicking filter maintenance
Wicking Filter performance will diminish depending on the mineral content of the water and the
amount of airborne dust in the environment.
impoRtant: CHECK WICKING FILTER REGULARLY. Any of the following conditions indicate
that it is time to replace the Wicking Filter.
A buildup of impurities and minerals on the Wicking Filter (evidenced by discoloration of
the Wicking Filter)
An appreciable decrease in Humidifier output — the humidifier will run for increasingly
longer periods between fillings
The top of the Wicking Filter is not moist to the touch
The Wicking Filter has large holes or tears
The Wicking Filter should be replaced at least one or two times during the season, depending
on usage, mineral content of the water and the environment. We encourage you to only use a
Kaz Model WF2 Replacement Wicking Filter. The use of other Wicking Filters may lead to
substandard performance.
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents