Service; Troubleshooting - Beltronics Ultimate Pro 100 Owner's Manual

Troubleshooting

Problem Solution
• An X or K-band motion sensor or intrusion alarm is
The Pro100 beeps briefly at the
located within range of your route.With time,you will learn
same location every day,but no
predictable patterns of these signals.
radar source is in sight.
• Make sure that windshield wipers do not block your
The Pro100 does not seem sensitive
Pro100's radar antenna and that the laser lens is not behind
to radar or laser.
tinted areas.
• Determine if your vehicle has an Instaclear ® ,ElectriClear ®
or solar reflective windshield which may deflect radar or laser
signals.
•Your Pro100 may be in City Mode.
• VASCAR (Visual Average Speed Computer and Recorder) a
The Pro100 did not alert when a
stopwatch method of speed detection,may be in use.
police car was in view.
• Officer may not have radar or laser unit turned on.
• Safety transmitters may not be commonly used in your area.
The Pro100 did not provide a Safety
signal while within range of an
emergency vehicle.
• Press the BRT button to deactivate Dark Mode.
The Pro100's display is not working.
•The Pro100 is in AutoMute Mode.See page 8 for details.
The Pro100's audible alerts are less
loud after the first few alerts.
•The Pro100 is not making contact with the windshield
The Pro100 bounces or sags on
to provide stability.While holding down the Pro100's
windshield.
QuickMount button,slide the Pro100 toward the windshield
so that the back top edge makes firm contact.
• A loose power connection or dirty lighter socket can cause
The Pro100's power-on sequence
the Pro100 to be briefly disconnected.
reoccurs while you are driving.
22
Problem Solution
Your 14-year old son has changed •You can return all of the programming options to the
all 6 of the Programming options. factory defaults by holding down the CITY and BRT buttons
while you turn the Pro100 on.
The Pro100 will not turn on. • Check that the power is ON.
• Check that vehicle ignition is ON.
• Check that vehicle lighter socket is functional.
•Try the
The Pro100 feels very warm. • It is normal for the Pro100 to feel warm.
Explanation of Displays
HD
Sensitivity control is in Highway mode,display is in Dark mode (page 9)
CD
Sensitivity control is in City mode,display is in Dark mode (page 9)
No display The Pro100 is in the Dark mode (page 9)
PilotHWY
One of the many programming messages (pages 11-14)
WorkZone
One of the many Safety Radar messages (pages 20-21)
Caution
The Pro100 has detected a Safety Radar Signal,but the signal isn't yet strong
enough to decode the specific safety message (page 20-21)
Self Cal
The Pro100 is running a self-calibration test

Service

The Pro100 has failed the calibration test.Contact Beltronics for repair
Required
Pro100
in another vehicle.
23