Weider WEBE05590 User Manual page 8

7. Tap a 1Ó Square Inner Cap (35) into the indicated
ends of the two Backrest Tubes (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M6 x 38mm Screws (30) and two M6
Washers (26). Note: Do not tighten the Screws
fully.
8. Tap a 3/4Ó Round Inner Cap (9) into each end of
the Support Rod (7). Insert the Support Rod
through one of the three upper sets of holes in
the Uprights (1). Rotate the Support Rod to the
locked position, with the locking pin wrapped
around the Upright.
Lubricate the M10 x 135mm Bolt (36). Attach the
Backrest Tubes (5) to the welded tube on the
Frame (2) with the Bolt, two M10 Washers (34)
and an M10 Nylon Locknut (33) Fully tighten all
four M6 x 38mm Screws (30) used in step 7.
9. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (29) and four M6
Washers (26).
10. Tap a Fly Arm Stop (15) onto the welded tube on
each Upright (1).
7
5
30
26
8
36
34
33
34
Welded Tube
9
11
2
26
29
10
1
8
30
35
26
6
1
9
7
2
1
Locking Pin
26
29
1
15
9