A&D UA-1020 Instruction Manual page 7

Symbols
Appears during measurement when
the cuff is applied loosely.
Previous measurements stored in memory.
Average data
The battery power indicator during
measurement.
Full Battery
The battery power is low when it
blinks.
Low Battery
Unstable blood pressure due to
movement during measurement.
The systolic and diastolic values are
within 10 mmHg of each other.
The pressure value did not increase
during the inflation.
The cuff is not applied correctly.
The pulse is not detected correctly.
PUL. DISPLAY ERROR
Blood pressure monitor internal error
Systolic blood pressure in mmHg
SYS.
Diastolic blood pressure in mmHg
DIA.
Pulse per minute
PUL./min.
Data taken between 4:00 and 9:59
AM
Data taken between 18:00 and 1:59
PM
Pressure settings
Indicates the pressure value
previously set by the user.
Function / Meaning
English 6
Recommended Action
The reading may yield an
incorrect value. Apply the
cuff correctly, and take
another measurement.
Replace all batteries with new
ones when the mark blinks.
Take another measurement.
Remain still during
measurement.
Apply the cuff correctly,
and take another
measurement.
Remove the batteries and
press the START button,
and then install the batteries
again. If the error still
appears, contact the dealer.