Calibrating.the.sensor.automatically; Calibrating.the.sensor.manually; Indiglo Night-Light/Night-Mode Feature; Battery - Timex Health Tracker Instruction Manual

TIp: If goal is set to be measured in distance, step equivalent is automatically calculated using personal
settings. If goal is set to be measured in steps, distance equivalent is automatically calculated.
Calibrating the SenSor aUtomatiCally
Calibrate the sensor for more accurate pace and distance calculations.
1. Press MODE to select SETUP.
2. Press START/STOP/RESET/- to select STRIDE SETUP.
3. Press and hold SET until values to edit flash.
4. Press + and - to select AUTOMATIC. Press NEXT.
5. Press + and - to select WALK or RUN.
6. Press NEXT and + / - to set thousands digit of CAL. LENGTH (this is the distance to walk or run to calibrate).
7. Continue pressing NEXT and + / - to set remaining digits. Press NEXT when finished.
8. When prompted, hold START.
9. When prompted, walk or run selected distance.
10. When distance is reached, press STOP.
If CALIBRATION OKAY displays, setup is complete. If CALIBRATION FAILED displays, repeat calibration.
TIp: Longer distances make more accurate calibrations than shorter ones. The default distance is the distance
of a football field from end zone to end zone (300 ft or 91m).
Calibrating the SenSor manUally
1. If you know your stride length, you can enter the exact measurement without running automatic
calibration. Calibrating the sensor to your precise stride length will result in the most accurate distance
calculations from Health Tracker
2. Press START/STOP/RESET/- to select STRIDE SETUP.
3. Press and hold SET until values to edit flash.
4. Press + and - to select MANUAL.
5. Press + / - and NEXT to set stride length in feet (meters) and inches (centimeters).
6. Press DONE to save settings and exit.
indiglo night-light/night-mode
®
1. Press INDIGLO button to activate night-light for several seconds.
®
2. Hold INDIGLO button for 4 seconds to activate NIGHT-MODE
®
3. In NIGHT-MODE ® feature, press any button to activate night-light.
4. Hold INDIGLO button for 4 seconds to turn off NIGHT-MODE
®
feature automatically turns off after 8 hours.

baTTeRY

Battery type is on watch back. Battery life may vary depending on actual usage.
1. Rotate battery hatch counter-clockwise, following OPEN arrow.
Remove battery hatch (use a coin if battery hatch is difficult to
remove).
2. Rotate plastic cover counter-clockwise until OPEN
toward top of watch. Remove plastic cover. Remove battery.
3. Insert new battery.
4. Replace plastic cover. Rotate plastic cover clockwise until CLOSE
icon points toward top of watch.
5. Use paper clip to press reset pad in hole.
6. Replace battery hatch. Rotate hatch clockwise, following CLOSE
arrow.
TIp: To help preserve battery life, you can turn the activity sensor off in
the SYSTEM SETUP menu. Watch will not count steps when sensor is off.
Do noT DIspose of baTTeRY In fIRe. Do noT ReCHaRGe. Keep loose baTTeRIes aWaY fRoM
CHIlDRen.
™ watch. Press MODE to select SETUP.
featUre
®
r
icon points
8
feature. Beep will sound.
®
feature. Beep will sound. NIGHT-MODE
®
r
®