Appendix; Add And RegSter A Handset; Screen Messages - VTech CS6114 Complete User's Manual

Appendix

Add and register a handset
When To register HS and See manual appears alternately on the handset, the
handset s deregstered from the telephone base. Follow the steps below to regster
the handset to the telephone base.
To register a handset:
1. Remove the handset from the telephone base, and make sure no handset s
n use.
Press and hold /FIND HANDSET on the telephone base for about sx seconds.
2.
Then press # (pound key) on the handset. It dsplays Registering... and t takes
3.
about 60 seconds to complete the regstraton. The handset dsplays Registered
for a few seconds and you hear a confirmation tone when the registration
process completes.

Screen messages

Call log empty
Directory empty
Directory full
Ended X:XX:XX
Incoming call
Line in use
Low battery
Microphone on
Muted
New voicemail
No battery
No line
Not available
Number repeated
Out of range or no
pwr at base
There are no caller ID log entres.
There are no drectory entres.
The drectory s full.
You have just ended a call.
There s an ncomng call.
A system handset s n use, or another telephone on the same
lne s n use.
The battery needs to be recharged.
MUTE s turned off and the person on the other end can hear you.
You have turned off the handset mcrophone. The other party
cannot hear you but you can hear the other party.
There are new vocemal message(s) from the telephone servce
provder.
No battery s nstalled. Follow the drectons for battery nstallaton
on page 4 to nstall the battery before chargng.
There s no telephone lne connected.
One handset s already revewng the caller ID log and the other
handset tres to revew t.
The telephone number you enter s already stored n the
drectory.
The handset cannot communcate wth the telephone base.
Check the telephone base power connecton or move the handset
closer to the telephone base.
27