Hitachi DZ-HS300A Instruction Manual page 142

Message
DVD error has occurred.
Formatting is not
complete.
DVD error has occurred.
Keep DVD inside &
restart.
DVD error has occurred.
Please keep DVD inside
and set power switch to
"DVD".
DVD error has occurred.
Unfinalizing is not
complete.
DVD error has occurred. • Use another disc.
DVD full. Cannot
execute.
DVD must be finalized
before it can be played
back on DVD player or
DVD recorder.
Drive overheat. Please
retry later.
DVD-R* cannot dub the
scene recorded in STD
mode and 16:9.
DVD-R*, Different video
mode, 16:9 and 4:3
mode cannot exist
together.
DVD-R*, 16:9 mode
cannot be changed,
when Video mode is
STD.
142
Cause & Troubleshooting
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before
reusing it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
Disc error could have occurred during editing of scenes.
Turn off the DVD video camera/recorder with the disc being used
in it, connect AC adapter/charger, and then power the DVD video
camera/recorder again. Repair of scenes will be tried.
This message will appear if disc error has occurred during
dubbing. Connect the AC adapter/charger to DVD video camera/
recorder, and set the power switch to "DVD": Video file will be
repaired.
This message will appear when disc error occurred during
unfinalization, and unfinalizing disc failed. Replace the disc.
• See *3 and *4 on page 145.
• Mismatch in recording information may be caused by editing
done on some device other than this DVD video camera/
recorder.
Initialize the disc or use another disc.
• Initializing the disc will erase all data on it.
This message will appear if the capacity of the scene selected is
larger than the free space on disc. Select another scene, or use
another DVD.
• This message will appear if you remove a DVD-RW (VF-mode)/
DVD-R that has not been finalized from the DVD video camera/
recorder.
• See *5 on page 145.
The temperature inside the DVD video camera/recorder is too
high, and writing to disc or reading from HDD or disc may not be
performed normally.
Turn the DVD video camera/recorder off and wait for a while. The
temperature will be effectively decreased if the DVD video
camera/recorder is placed in a well-ventilated spot.
With a DVD-RW (VF-mode)/DVD-R/+RW, no video can be
recorded with a combination of movie quality "STD" and 16:9
mode "On". Replace the disc with a DVD-RAM or DVD-RW (VR-
mode) for dubbing.
* "DVD-RW (VF)" will appear when using a DVD-RW (VF-mode),
"+RW" will appear when using a +RW.
With a DVD-RW (VF-mode)/DVD-R, the movie quality mode and
16:9 mode cannot be changed in the middle of disc: Change the
movie to be dubbed or replace the disc with a DVD-RAM or DVD-
RW (VR-mode).
* "DVD-RW (VF)" will appear when using a DVD-RW (VF-mode).
With DVD-RW (VF-mode)/DVD-R/+RW, the setting of 16:9 mode
will not be possible when the Video mode is STD.
* "DVD-RW (VF)" will appear when using a DVD-RW (VF-mode),
"+RW" will appear when using a +RW.
Reference
page
11, 105
28
33
109
11, 26
105
83
114
33
85
66
66