Kolcraft Contours Options Instruction Sheet page 13

To Secure All Acceptable Infant Car Seats
1 & 2
3
Belt Slots
3
Lowest Center Point
5
6
6
WARNING
When using this product, to avoid
serious injury from falling or sliding
out, infant must always be secured in
the Infant Car Seat with the Car Seat
harness. Refer to Infant Car Seat
Instructions for proper adjustment.
Remove restraint buckles from bag locat-
1
ed on frame of stroller. With one hand,
grasp the Infant Car Seat handle (in its
upright, carrying position). With your
other hand, grasp Infant Car Seat near
baby's feet. Gently position the Infant
Car Seat above Infant Car Seat Adapter
so the baby faces the stroller handle.
Lower the Infant Car Seat between
2
the front & rear bars.
Thread RED infant car seat restraint belts
3
located in the side pocket through the
clips on the top of the car seat. Tighten
Restraint Straps. Special Instructions for
Car Seats without belt slots: Secure Infant
Car Seat to Adapter by wrapping restraint
around frame and over seats lowest
center point near handle and buckle them
together. Tighten Restraint Straps.
NOTE: Shopping cart lever will not lock
onto the carrier. To secure infant car seat
to carrier, use restraint straps.
To Secure Infant Car Seat
Lock both foot brakes to keep stroller
4
from rolling.
To fasten car seat restraint belts - open
5
up loop of the restraint belt. Adjust belt
until the buckles almost touch.
Pull end tab of restraint belt to set.
6
Push buckles together to secure.
13
Continued on next page