Using The Label Peeler (Optional:pa-Lp-001) (Td-2120N/2130N Only); Inserting The Rd Roll - Brother TD-2020 User Manual

Using the Label Peeler
13
(Optional:PA-LP-001)
(TD-2120N/2130N only)
If the label peeler is used, printed labels can
be automatically peeled off their backing
paper before they are fed out of the media
exit. This is useful when affixing a large
amount of printed labels.
Follow the procedure below to load the
correct paper.
For details on attaching the label peeler
(optional), see its instruction manual.
Before using the label peeler, the
setting for using the label peeler must
be specified in the printer driver. For
details, see Printer Driver Settings
on page 109.

Inserting the RD Roll

 When using the peeling function of the
label peeler to peel off labels while
printing:
 Be sure to use genuine Brother roll
media.
 Be sure to use die-cut labels. Do not
use any other labels.
106
a
Press and hold the
turn the printer off.
Press the cover release lever (1) on
either side and lift up to open the RD
Roll compartment top cover.
13
b
Open the media guides by lifting up the
media guide adjustment lever (1) and
pulling the media guides outwards.
NOTE
The media guides are shipped fully open
from the factory.
13
(Power) button to
1
1