Razor Graffiti Owner's Manual page 5

SET UP aND USagE INSTRUCTIONS
q Installing your chalk
1
Insert the tapered end of the
chalk into the spring.
q How to Ride
Place one foot on the baseboard, push forward with the other foot. Steer. For enhanced cornering, lean slightly into the
direction of the turn. For controlled stops, apply the brake by stepping on the rear fender/brake. Razor recommends that
you practice applying the brake at various speeds and in an open area free from obstructions before riding your Razor
around others.
q Using the Chalk Bar
When riding, place ball of foot on the chalk bar and apply pressure until the chalking mechanism clicks into place. Only
use enough pressure to cause chalk to make a mark. To stop chalking, place ball of foot on chalk bar and apply pressure
until it clicks to the desired position.
1
Up Position - No chalking
Need Help? Visit www.razor.com for replacement parts, product support and a list of authorized
service centers or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
2
Twist chalk clockwise 1/4 turn
until chalk is set securely in the
spring. Periodically turn chalk as
needed.
2
Down Position - Chalking
4
WaRNINg: Keep fingers
clear of chalk bar hinge and fender
brake.
NOTE: Chalk is non-toxic.
Conforms to ASTM4236.
Chalk washes off with water for
easy clean-up.
WaRNINg: Applying too
much pressure on the chalk bar may
cause loss of control.
NOTE: Using any other part of
the foot or full foot may activate the
brake and prevent the chalk action.
NOTE: Chalk marks and
chalk life will vary based
on the amount of pressure
applied to the chalk bar and
the smoothness of the riding
surface.