Advertisement
ASSEMBLY INSTRUCTIONS
WARNING: Failure to properly install and tighten the handlebar
T-tube clamp may cause the rider to lose control and fall. Assembly must be
performed by an adult with mechanical experience. If you do not understand
these instructions or the concept of "tighten securely" seek the assistance of a
qualified mechanic.
ASSEMBLY INSTRUCTIONS (refer to photos on page 7):
A. Slide the T-tube assembly onto the exposed threads of the fork.
B. With the front wheel pointed straight ahead and the handlebars square to
the front wheel, tighten the clamp as shown. Tighten securely.
C. Align the spring buttons with the holes on the T-tube and insert the
handlebars until the spring buttons are engaged as shown.
D. Adjust the handlebar height to a comfortable position using the quick
release. Push the lever closed to lock the T-tube position.
RAZOR SAFETY TIPS
A. Always wear proper protective equipment, such as an ANSI, SNELL,
CPSC or ASTM approved helmet and elbow and kneepads. Long sleeve
shirt, gloves, long pants, shoes, and elbow and knee pads are mandatory.
Always wear a helmet when riding your scooter and keep the chinstrap
securely buckled. Always wear shoes. Do not ride barefoot or in sandals.
Keep shoelaces out of the way of the wheels.
B. Ride on smooth, paved surfaces away from motor vehicles.
WARNING: Do not ride on wet, slippery surfaces or icy
conditions. You will lose traction and could fall.
C. Avoid sharp bumps, drainage grates and sudden surface changes.
Scooter may suddenly stop.
D. Avoid streets and surfaces with water, sand gravel, dirt, leaves, and other
debris. Weather impares traction, braking and visibility. Avoid anything that
could cause your front wheel to stop. Bumps have the potential to stop the
front wheel. When in doubt, avoid the bumps.
(Continued on Page 8)
6
A
WARNING: Failure to properly engage the spring-loaded buttons
may cause the handlebars to dislodge while riding and may cause you to lose
control and fall. When correctly engaged, the handlebars will not rotate nor
will they move sideways. Note that when properly engaged, the spring-loaded
buttons are clearly visible in the holes on the T-tube as shown above right.
D
B
C
C
WARNING: Failure to properly
engage the quick-release clamp may
cause the T-tube to telescope up or down
while riding which may cause you to lose
control and fall. With the quick-release
properly engaged, the handlebars will not
move up or down.
7
Advertisement
