Table of Contents
Advertisement
SECTION 5: UNPACKING INSTRUCTIONS
REMOVE UNIT FROM CARTON
• See Figure 3.
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
• Remove loose parts if included with unit (i.e., operator's manual, etc.).
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
• Roll or slide unit out of carton. Check carton thoroughly for loose parts.
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it against the
engine by attaching rubber boot to a bolt or metal clip to the grounding post on the engine. See Figure 4.
REMOVE MANUAL & LOOSE PARTS
PUSH
Figure 3
Spark Plug Wire
Figure 4
Spark Plug
7
Advertisement
Table of Contents
