Power Supply - Ryobi C-356 TYPE III Owner's Operating Manual

OPERATING
POWER SUPPLY
Before operating your,cut-off machine, check your
power supply and make sure it meets the requirements
listed on the nameplate. A substantial voltage drop will
cause a loss of power and machine overheating.
Co mm on cause s o f p o we r l o s s a n d m a c h in e
overheating are insufficient extension cord size and
multiple tools operating from the same power source.
SWITCH
To start the tool. completely depress the trigger switch
located in the rnachine handle (Figure 10).
To stop the tool, release the trigger switch completely.
For continuous operation, completely depress the
trigger switch and, while holding it in place (tool running),
depress the trigger lock-on button located to the left of
tne trigger switch on the tool handle (Figure 10).
To discontinue continuous operation when using the
trigger lock-on feature, completely depress the onlott
trigger switch and then release it. This action will
disengage the trigger lock-on feature.
CUTTING
WARNING: Do not attempt to cut wood
or rnasonry with this machine. Never
cut magnesium or magnesium alloy with
this tool. Failure to comply with this
warning coufd result in serious personal
inju ry.
F igur e 10
F i gur e 1 1
procedure.
1.
2 .
Secure the tool in place to
Firmly secure the material
prevent machine movement or tipping during the cutting
to b e c u t u s in g th e m a c h in e ' s v is e (F igure 1 1).
3 .
4 .
5 .
WARNING: Large, circular, or irregularly shaped material may require additional means
of clamping to be secured in place adequately for cutting. Use "C" clamps and blocks to
hold material securely. Failure to comply could result in serious personal injury.
Start the machine by fully depressing the trigger switch and allow the cut-otf wheel to come up to full speed
before contacting wheel to material.
Slowly push down on the machine arm handle until the cut-off wheel contacts the material being cut. Use
a steady and even pressure to obtain a uniform cut. Never force the wheel into the material.
When the cut is complete, release the trigger switch and allow the wheel to stop before raising it to the full
open position.
, n
DA N G ER : D o n o tt o u ch t h e cu t m ate r ia l u nt i l i tc o o ls o r yo u wi ll b e b u r n ed ! F a il u r e t ohe ed
-l
this warning will result in serious personal injury.
Pa g e 1 2