Attaching Lcd Options - Mitsubishi MDT401S User Manual

Attaching LCD Options

You can attach mounting accessories to the LCD monitor in one of
the following two ways:
1. In the upright position
2. Lay the screen face down
Table
To avoid damaging the screen face, place the protective sheet on
the table to lay the LCD on. The protective sheet was wrapped
around the LCD in the original packaging.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. For proper installation it is strongly
recommended to use a trained, MITSUBISHI authorized service per-
son. Failure to follow MITSUBISHI standard mounting procedures
could result in damage to the equipment or injury to the user or
installer. Product warranty does not cover damage caused by im-
proper installation. Failure to follow these recommendations could
result in voiding your warranty.
When using mounting accessories, other than MITSUBISHI compli-
ant and approved, they must be VESA-compatible mounting method.
MITSUBISHI strongly recommends using screws M6 size and 8mm
in length. If using screws longer than 8mm, check the depth of the
hole. (Recommended Fastern Force: 274 - 362N•cm)
MITSUBISHI recommends using mounting interface that comply with
UL1678 standard in North America.
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram to the right.
*Ambient temperature should be less than 40 deg C
Protective Sheet
To avoid falling down
Fasten the LCD monitor to a wall using a cord or chain which is
sufficient to support the weight of the LCD monitor (approx. 27.
5kg).
Tabletop Stand
Clamper
Before moving the LCD monitor, the cord or chain should be removed.
English-4
Screw Holes
Cord or Chain
Screw
*