Hardware Installation - Diamond View DV172 Manual

5
5

Hardware Installation

Your monitor is equipped with an automatic power supply with a voltage
range from 100 to 240 Volts AC at a frequency of 50 to 60 Hz. Make sure
that your local power supply is within the supported range. If you are
unsure, please contact your electricity supplier.
To install your Diamond View DV172 monitor:
1. Make sure that the power to the computer and the power to the monitor
are both turned off.
2. To use the VGA signal input, connect the D-sub cable from the analog
VGA connector (15-pin socket) of the computer's conventional graphics
card to the analog VGA connector (15-pin socket) of your monitor.
6