Table of Contents
Advertisement
Connecting the AM (MW)/LW Aerial
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not run close to the
aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting the FM Aerial
How to connect a COAXIAL TYPE aerial.
Connect a 75 antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket (75 ) marked FM on the rear of the system.
Follow the instructions given on Page 12 to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75 coaxial cable (not supplied).
Connecting the SW Aerial (option)
How to connect a SW TYPE aerial .
Spread the SW aerial out and attach the ends to a wall,in the
position providing the best reception.
If reception is poor (e.g.distance from transmitter too great,walls
blocking the radio waves ,etc),install an outdoor aerial.
MIC
GB
M1C
MIC
MIC
Advertisement
Table of Contents
