Searching For And Storing Radio Stations; Selecting A Stored (Preset)Station; Improving Radio Reception; Timer Function - Samsung MM-X5 Instruction Manual

Searching for and Storing Radio Stations

You can store up to:
GB
30 FM stations
1
Switch the system on by pressing ( ).
2
To listen to the Radio.
Remote Control
a Press the TUNER button.
b. Tune in to the desired station.
Automatic Tuning 1: When the or
button is
pressed,station you have preset are selected.
Automatic Tuning 2: Press and hold the or
automatically search for active broadcasting stations.
Manual Tuning:Briefly press the or
button to increase
or decrease the frequency incrementally.
Main Unit
a Press the Function button to select the TUNER.
b Select a broadcast station.
Automatic Tuning 1: Press the STOP( ( ) button to
select<PRESET> and then press the or
button to select
a station you've preset.
Automatic Tuning 2: Press the STOP( ( ) button to
select<MANUAL> and then press and hold the or
to automatically search the station.
Manual Tuning : Press the STOP( ( ) button to select<MAN-
UAL> and then briefly press the or
button to tune in to
a lower or higher frequency.
3 To store(Preset) station in Memory.
a Press the TUNER button.
b Pressing or buttons on the top panel or
buttons on the remote control to increase or decrease the
frequency respectively.
To scroll through the frequencies faster when
searching manually, hold down the or
The automatic search procedure may stop on a
frequency that does not correspond to a radio station. If
this happens, use the manual search mode.
c Press TUNER MEMORY.
Result: The current station NO is displayed for a few seconds.
d Pressing or buttons on the remote control to assign
a program number .
e Press TUNER MEMORY to store the radio station.
Result: The current station NO is no longer displayed and the sta-
tion is stored.
f To store any other radio frequencies required, repeat Steps b to e.
The SET function can be used to assign a new station to an exist-
ing program number.
2
2,3
1
2
DEMO/DIMMER
TUNER MEMORY REPEAT
SET 3
SET
DNSe EQ
2,3
2,3
14

Selecting a Stored (preset)Station

You can listen to a stored radio station as follows:
1
Switch the system on by pressing ( ) .
2 Press the TUNER button on the remote control.
Select the radio station as follows.
3
To listen to ... Press ...
Stored station or button to select the desired
button to
preset section.
2
DEMO/DIMMER
1
button
TUNER MEMORY REPEAT
SET
3
DNSe EQ
or
3
buttons.

Improving Radio Reception

You can improve the quality of radio reception by:
Rotating the FM antenna
If reception from a specific FM radio station is poor, press MONO/ST.
to switch from stereo mode to mono. The quality of the sound will be
improved.
TUNER MEMORY REPEAT
SET
DNSe EQ

Timer Function

The timer enables you to switch the system on or off at
specific times.
Example: You wish to wake up to music every morning.
If you no longer want the system to be switched on or off
automatically, you must cancel the timer.
Before setting the timer, check that the current time is correct.
For each step, you have a few seconds to set the desired option. If
you exceed the time, you must start again.
1 Switch the system on by pressing ( ) .
2
Press TIMER/CLOCK until TIMER is displayed.
Press SET.
3
Result: ON TIME is displayed (instead of the equalizer symbols) for
a few seconds, followed by any switch-on time already set;
you can set the timer switch-on time.
Set the timer switch-on time.
4
a Set the hour by pressing or button.
b Press SET.
Result: The minutes flash.
c Set the minutes by pressing or button.
d Press SET.
Result: OFF TIME is displayed (instead of the equalizer symbols)
for a few seconds, followed by any switch-off time already
set; you can now set the timer switch-off time.
5
Set the timer switch-off time.
a Set the hour by pressing or button.
b Press SET.
Result: The minutes flash.
c Set the minutes by pressing or button.
d Press SET.
Result: VOL XX is displayed, where XX corresponds to the
volume already set.
6
Press or button to adjust the volume level and press
SET.
Result: The source to be selected is displayed.
7
Press or button to select the source to be played when the
system switches on.
If you select... You must also...
TUNER (radio) a Press SET.
b Select a preset station by pressing
or .
MP3/CD (compact disc) Load a compact disc.
USB connect usb.
Press SET to confirm the timer.
8
Press ( ) to set the system to standby mode.
9
Result: is displayed to the left of the time, indicating that the timer
has been set. The system will switch on and off automatically
at the required times.
If the timer switch on and off times are identical, the word ERROR
is displayed.
.
DEMO/DIMMER
1,9
TUNER MEMORY REPEAT
SET SET
3,4,5,6,7,8
DNSe EQ
4,5,6,7
4,5,6,7
2

Cancelling the Timer

After having set the timer, it will start automatically as shown by the
TIMER indication on the display. If you no longer wish to use the
timer, you must cancel it.
You can stop the timer at any time (system on or in standby mode).
To... Press TIMER ON/OFF...
Cancel the timer Once.
Result: is no longer displayed.
Restart the timer Twice.
Result: is displayed again.
ON/OFF
15
GB