Clevo P170EM Service Manual page 43

Processor Installation Procedure
1. Insert the CPU , pay careful attention to the pin alignment
A
FORCE IT!), and turn the release latch
2. Remove the sticker (Figure
C
3. Insert the heat sink unit as indicated in
D
4. Tighten the CPU heat sink screws in the order
15d).
5. Replace the CPU fan, component bay cover and tighten the screws
a.
A
b.
B
(Figure
towards the lock symbol
B
15c) from the heat sink unit.
Figure 15c.
, &
, (the order as indicated on the label and
1 2 3 4
c.
C
D
d.
2 1
4 3
15a), it will fit only one way (DO NOT
(Figure 15b).
(page 2 - 17).
Note:
Tighten the screws in the order 1-2-
3-4 as indicated on the label.
Removing and Installing the Processor 2 - 19
Disassembly
Figure 15
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
Figure
wards the lock symbol.
c. Remove the sticker from
the heat sink unit and in-
sert the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 4 Screws