Water Drainage - Electrolux WA 1668 User Manual

26
Do not use an extension hose if the in-
let hose is too short. Contact the serv-
ice centre for the replacement of the in-
let hose.
Water-stop device
The inlet hose has a water stop device. This
device prevents water leaks in the hose be-
cause of its natural ageing. The red sector
in the window «A» shows this fault .
If this occur, close the water tap and con-
tact the service centre to replace the hose.

Water drainage

There are different procedures to connect
the drain hose:
With the plastic hose guide.
• On the edge of a sink.
Make sure that the plastic guide cannot
move when the appliance drains. Attach
the guide to the water tap or the wall.
• To a stand pipe with vent-hole.
A
Refer to the illustration. Directly into a
drain pipe at a height of not less than 60
cm and not more than 100 cm. The end
of the drain hose must always be ventila-
ted , i.e. the inner diameter of the drain-
pipe must be larger than the external di-
ameter of the drain hose.
Without the plastic hose guide.
• To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with a
clip. Make sure that the drain hose
makes a loop to prevent that remaining
particles go in the appliance from the
sink.
• Directly to a built-in drain pipe in the
room wall and tighten it with a clip.
You can extend the drain hose to maxi-
mum 400 cm. Contact the service cen-
tre for the other drain hose and the ex-
tension.