Completing The Set Up - Samsung Refrigerator User Manual

compression
Nut (1/4")
(Assembled)
Ferrule
(Not supplied)
copper tubing
(Not supplied)
Household water supply line
1. Connect the household water line to the
assembled compression fitting fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and ferrule (not
supplied) on the copper tubing (not supplied) as
shown.
- If you are using plastic tubing ( B ) , insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
Do not use without the molded end (Bulb) of
the plastic tubing ( B ).
cAuTION
2. Tighten the compression nut ( B ) onto the
compression fitting.
Do not over-tighten the compression nut ( B ) .
3. Turn water on and check for any leakage. If you
find water drops or leakage in the connection
areas, turn off the main water supply.
Check the connections and, if nescessary, tighten.
4. Flush 1 gallon of water through the filter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.)
To flush, press a large glass or cup against the
water dispenser lever.
Fill the glass, empty it into the kitchen sink after it
is filled, and then repeat.
5. After you turn on the refrigerator, let the ice maker
make ice for 1 to 2 days.
12_ setting up
DA68-02520A(0.4).indb 12
Refrigerator
Plastic Tubing
(Assembled)
compression
Fitting
(Assembled)
Molded end
(Bulb)
compression nut
(B) (1/4")
(Not supplied)
Plastic tubing (B)
or
(Not supplied)
Over that period of time, throw out the first 1 or
2 buckets of ice the freezer makes to ensure all
impurities have been removed from the water line.
Only connect the water line to a drinkable water
source.
If you have to repair or disassemble the water
line, cut off 1/4" of the plastic tubing to make
sure you get a snug, leak-free connection.

cOMPLETING THE SET uP

Now that you have your new refrigerator installed in
place, you are ready to set up and enjoy the features
and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
location with reasonable clearance between it and
the wall.
Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour.
The freezer will get slightly chilled and the motor
will run smoothly. Reset the refrigerator and freezer
to the temperatures you want.
4. After you plug the refrigerator in, it will take a few
hours to reach the appropriate temperature.
You can store food and drinks in the refrigerator
after the temperature is sufficiently cool.
2011.6.8 8:40:28 AM