Samsung Refrigerator User Manual page 7

AccESSORIES AND REquIRED
TOOLS
The following accessories are included with your
refrigerator:
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the
installation of your refirgerator:
Flat-blade screwdriver
Philips screwdriver (+)
Pliers
REMOvING THE REFRIGERATOR
DOORS
For some installations you need to remove the fridge
and flex doors and the freezer drawer so you can move
the refrigerator to its final location. Do not remove the
doors/drawer if you don't need to. If you do not need to
remove the refrigerator doors, go to Adjusting the Level
on page 9. If you need to remove the doors. continue
below. Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the doors or drawer.
WARNING
• Be careful not to drop, damage, or scratch
the doors/drawer while removing them.
• Be careful not to injure yourself while removing the
doors/drawer.
DA68-02520A(0.4).indb 7
Fastener
Socket wrench
(-) (10mm)
Allen wrench (3/16") (5mm)
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
-
Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors
while removing the doors.
WARNING
Disassemble the refrigerator doors
1. With the door opened, remove the cap top table
( 1 ) with a flat-blade screwdriver (-), and then
close the door.
Remove the 3 screws holding down the top table
( 2 ) and turn it with several wires connected.
1
2. Disconnect one connector ( 3 ) on the right side
door and one connector ( 4 ) on the left side door.
Remove the water line ( 5 ) while pressing the dark
gray part ( 6 ) of the water line coupler.
4
Red clip
(1/4")
5
6
If a red clip is on the coupler, it must be
removed before removing the tube.
cAuTION
2
3
setting up _07
2011.6.8 8:39:38 AM