Network Settings; Network Connection - Cable - Samsung Plasma TV User Manual

Network Settings

Network Connection - Cable

LAN Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below.
Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do
not have to enter them manually.
The Modem Port on
the Wall
1 Connect the [LAN] port on the rear panel of the TV and the external modem with a LAN Cable.
2 Connect the LAN port on the wall and the external modem with a Modem Cable.
You can connect the LAN via a Sharer (Router).
The Modem Port on
the Wall
You can connect the LAN port and the TV directly depending on your network status.
The LAN Port on
the Wall
The terminals (the position of the port and the type) of the external device may differ depending on the
➣
manufacturer.
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at
➣
least 10 seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner's manual of the
➣
corresponding product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router)
➣
You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use
➣
an automatic-connection-type ADSL modem.
External Modem
(ADSL/VDSL/Cable TV)
2 Modem Cable
IP Sharer
External Modem
(ADSL/VDSL/Cable
TV)
LAN Cable
Modem Cable
LAN Cable
English - 110
LAN Cable
1
TV Rear Panel
LAN Cable
TV Rear Panel
TV Rear Panel