Setup; Operation; Important Safety Information - Chicago Electric 69696 Owner's Manual & Safety Instructions

Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
Installing a Backing Pad
1. The accessory MUST be:
• rated to at least 4,000 RPM.
• no larger than 7" (178 mm) in diameter.
• fitted with a threaded opening of 5/8" x 11 TPI.
• undamaged.
• a backing pad.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
Polishing Instructions
TO PREVENT SERIOUS INJURY:
Grip the tool firmly in both hands.
1. Wash the work surface thoroughly, and
make sure it is free of dust, dirt, oil, grease, etc.
2. Place a clean Foam Pad (sold separately)
securely onto the Backing Pad.
2. Apply about two tablespoons of wax
(not included) evenly on the clean Foam Pad.
NOTICE: Do not apply the wax directly to the surface
of the vehicle. The amount of wax needed will vary
according to the size of the vehicle being waxed.
NOTICE: Only use slower speeds for polishing.
Otherwise, damage may occur to the paint
being polished. Harbor Freight Tools is not
responsible for damage to the vehicle's
finish due to improper use of this tool.
3. Make sure that the Switch is in the
off-position, then plug in the tool.
Page 10 For technical questions, please call 1-800-444-3353.
2. Press in and hold the Spindle Lock to
prevent the Spindle from turning.
3. Thread backing pad firmly onto the Spindle.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment
including, but not limited to,
ANSI-approved eye and hearing protection.
WARNING! To prevent electric shock,
keep electrical connections off ground.
CAUTION! Start and stop the tool only while it
is held firmly against the surface of the vehicle.
Failure to do so may result in the Foam Pad or
Polishing Bonnet being thrown from the Polishing Pad.
4. To start, position the unit on the area to be polished,
grip the tool firmly with both hands
and turn the Power Switch to "1".
Turn the Power Switch to "0" to stop.
5. Use the buttons on the control panel
to adjust the speed as desired.
6. Keep pressure off of the tool when operating.
The Foam Pad should LIGHTLY
contact the polishing surface.
Item 69696