Craftsman 919.195413 Owner's Manual page 17

5. Move the Auto/Off switch to "Auto"
position. The compressor will start.
6. Run the compressor for 20 min-
utes. Make sure the drain valve
is open and there is minimal air
pressure build-up in tank.
7. After 20 minutes, close the drain
valve by turning clockwise. The air
receiver will fill to "cut-out" pres-
sure and the motor will stop.
The compressor is now ready for use.
Before Each Start-Up
1. Set the Auto/Off switch to "Off".
2. Pull regulator knob out, turn
counterclockwise until it stops.
Push knob in to lock in place.
3. Attach hose and accessories.
NOTE: The hose or accessory will
require a quick connect plug if the
air outlet is equipped with a quick
connect socket.
grasp air hose in hand when
installing or disconnecting to
prevent hose whip.
use damaged or worn accessories.
pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air
tools and accessories. The regulator
outlet pressure must never exceed
the maximum pressure rating.
Risk of unsafe
operation. Firmly
Risk of unsafe
operation. Do not
Risk of Bursting.
Too much air
Compressed air from the unit may
contain wa ter condensation and
oil mist. Do not spray un fil tered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the in struc tions for the air
tools and accessories.
How to Start
1. Set the Auto/Off switch to "Auto"
and allow tank pressure to build.
Motor will stop when tank pressure
reaches "cut-out" pressure.
2. Pull the regulator knob out and
turn clockwise to increase pres-
sure. When the desired pressure
is reached push knob in to lock in
place.
is noticed, stop the compressor
immediately and have it checked by
a trained service technician.
The compressor is ready for use.
17 - ENG
Risk of unsafe
operation.
If any unusual
noise or vibration
N000578