Craftsman 919.195413 Owner's Manual page 12

Oil lubricated single stage horizontal portable air compressor
Hide thumbs Also See for 919.195413:
Table of Contents

Advertisement

Available languages

Available languages

5.
Rotate each retaining clip clock-
wise and press down until it
snaps into place over the handle.
Retaining
Clip
6.
If the handle has excessive
movement, it is improperly
installed. Check the following.
A.
Are both tabs inside the
handle (Step #3)?
B. Does each clip pass through
both the saddle and handle
(Step #4)?
TO ASSEMBLE WHEELS
It will be necessary
to brace or support
one side of the air compressor when
installing the wheels because the
compressor will have a tendency to
tip.
1.
Attach wheels with shoulder bolts
and nuts as shown.
2.
Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
N000578
provide adequate clearance, stability
or support for pulling the unit up and
down stairs or steps. The unit must
Handle
be lifted, or pushed up a ramp.
ASSEMBLE RUBBER FEET
1.
2.
OIL FOR PUMP
the pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.
12- ENG
The wheels and
handle do not
Attach rubber feet with the
screws, washers and nuts pro-
vided as shown in figure below.
Tighten securely.
Nut
Flat Washer
Rubber Foot
Screw
This compressor was
shipped with oil in
Nut
Wheel
Shoulder
Bolt

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents