Impex OLYMPIAN Owner's Manual page 9

STEP 4 (See Diagram 4)
A.) Attach the Seat Bracket (#12) to the short pivot on the Sliding Block. Secure it with one M10
x 5" Allen Bolt (#57), two
B.) Place the Backrest Incline Support (#7) in between the two Backrest Supports (#9). Attach
the Backrest Supports to the long Pivot on the Sliding Block.
C.) Place the Backrest Board (#19) onto the Backrest Supports. Secure it with four M6 x 1 3/8"
Hex Bolts (#64) and
D.) Push two Ø ¾" Bushings (#51) into the bottom of Backrest Incline Support (#7) and attach it
to the bracket on the Main Seat Support (#6). Secure it with one M12 x 3 3/8" Hex Bolt (#56),
two Ø 1" Washers (#69), and one M12 Aircraft Nut (#66).
E.) Place the Seat Pad (#18) onto the Seat Bracket. Secure it with four M6 x 5/8" Hex Bolts
(#65) and ½" Washers (#71). Insert a 4" L-shaped Pin (#32) into the selected hole on the
Seat Bracket to hold the desired seat incline.
¾" Washers (#70), and one M10 Aircraft Nut (#67).
½" Washers (#71).
8
DIAGRAM 4