Impex OLYMPIAN Owner's Manual page 11

STEP 6 (See Diagram 6)
A.) Attach the ball end of the Cable (#11) to a Pulley (#37). Place the Pulley in the open slot
on top of the Lat Bar Frame (#22). Secure the Pulley with one M10 x 2 3/8" Allen Bolt
(#61), two Pulley Bushings (#34), and one M10 Aircraft Nut (#67).
B.) Draw the Cable over the Pulley to the open bracket on the Lat Bar Frame. Attach a Pulley
to the bracket. Secure it with one M10 x 2" Allen Bolt (#60), one L-shaped Pulley Cover
(#33), two ¾" Washers (#70), and one M10 Aircraft Nut (#67).
C.) Draw the Cable over the Pulley then downward to the Sliding Weight Holder (#23). Secure
the tip of the Cable to the Weight Holder with one M10 x 1" Allen Bolt (#59), two
Washers (#70), and one M10 Aircraft Nut (#67).
D.) Connect the Lat Bar (#24) by using a C-clip (#28) to the Chain (#29). Adjust the length of
Chain to obtain the desired height of the Lat Bar exercise. Connect the Chain to the
Cable (#11) with another C-clip (#28).
10
¾"