Advertisement
SWING SPOUT ASSEMBLY
Turn off hot and cold water
CAUTION
supplies before beginning.
Apply the grease (provided) liberally to the
SPOUT O-RING
and SNAP RING
(1)
Assemble the SPOUT
(3)
SPOUT NUT
until snug on VALVE BODY.
(4)
FITTING INSTALLATION
Remove LOCKNUT
, BRASS WASHER
(1)
GASKET
from fitting.
(3)
Place RUBBER RING
in recess of fitting.
(4)
Insert inlet hoses and THREADED SHANK through hole of sink
making certain RUBBER RING
of the fitting base.
Assemble GASKET
, BRASS WASHER
(3)
onto the THREADED SHANK from underside of sink deck.
Tighten the LOCKNUT
(1)
Connect the hot water supply to the left inlet hose
and the cold water supply to the right inlet hose
using appropriate connectors.
TEST INSTALLED FAUCET
Remove AERATOR.
With handle in OFF position, turn on water supplies
and check all connections for leaks.
SERVICE
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90 and replace.
Replace SPRING CLIP (1).
Replace ADAPTER, HANDLE, SCREW, and INSERT.
EverClean™ Finish Care Instructions
American Standard's EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with
clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
areas.
(2)
and tighten the
, and
(2)
is properly seated in the recess
(4)
, and LOCKNUT
(2)
securely.
2
90
(1)
INLET HOSES
Operate both handles to flush water lines thoroughly.
Checkspout mounting and hose connections for leaks.
Turn handles into OFF position and replace AERATOR.
AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90 .
1
Plastic SCREEN (3) in CARTRIDGE (4) may accumulate
dirt causing reduced water flow. To clean, first turn
off hot and cold water supplies, then:
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Unscrew CARTRIDGE (4) with wrench.
Thoroughly rinse plastic SCREEN (3) at
base of CARTRIDGE (4).
Replace CARTRIDGE (4) until flange is
tight against valve body.
Turn valves OFF.
Replace ADAPTER, HANDLE, SCREW,
and INSERT.
RECESS
1
HOT
FLEXIBLE
COLD
3
4
2
1
4
3
2
4
3
Advertisement
