Jumper Cables - Husqvarna MZ28T Operator's Manual

Weak Battery
WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks, fl ame
and smoking materials away from
batteries. Always wear eye protection
when around batteries.
IMPORTANT INFORMATION
The mower is equipped with a 12-volt negative
grounded system. The other vehicle must also
be a 12-volt negative grounded system. Do not
use the mower to start other vehicles.
IMPORTANT INFORMATION
Refer to the EFM Information Sheet from the
unit literature packet for specifi c jump starting
instructions.
If "jumper cables" are used for emergency starting,
follow this procedure:

Jumper Cables

• Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
• Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged battery.
• Connect the other end of the BLACK cable to a
good CHASSIS GROUND on the mower with the
discharged battery, away from the fuel tank and
battery.
To remove cables, reverse order
• Remove BLACK cable fi rst from chassis and then
from the fully charged battery.
• Remove RED cable last from both batteries.
28
-Husqvarna
OPERATION
Jumper cable connection
8011-642