Safety Instr Uctions; Personal Protection; Machine ' S Safety Equipment - Husqvarna LC 48 Operator's Manual

Personal protection

WARNING! You must use personal protection
!
whenever you use the machine.
• Gloves must be worn when required, for example when
fitting, inspecting or cleaning cutting attachments.
• Always wear heavy, long pants. Do not wear shorts,
sandals or go barefoot.
• Wear sturdy, non-slip boots or shoes.
Generally clothes should be close-fitting without restricting
your freedom of movement.
Machine' ' ' ' s safety equipment
This section describes the machine's safety equipment, its
purpose, and how checks and maintenance should be carried
out to ensure that it operates correctly. See the "What is
what?" section to locate where this equipment is positioned
on your machine.
WARNING! Never use a machine that has
!
faulty safety equipment! Carry out the
inspection, maintenance and service
routines listed in this section.
Cutting cover
The cutting cover is designed to reduce vibration and to
reduce the risk of cuts. Make sure the cutting cover is not
damaged and that there are no visible defects such as cracks.
Engine brake handle
The engine brake is designed to stop the engine. When the
grip on the engine brake handle is released the engine should
stop.
• Check that the engine brake works correctly and is
undamaged.
Place the lawn mower on firm, flat surface and start it.
Make sure that the cutter cannot come into contact with
the ground or other objects.
Apply full throttle and then release the brake handle. The
engine brake should always be adjusted so that the
engine stops within 3 seconds. If this does not happen,
the machine should be handed in to an authorized
servicing dealer for adjustment.

SAFETY INSTR UCTIONS

Muffler
The muffler is designed to keep noise levels to a minimum
and to direct exhaust fumes away from the user.
WARNING! The exhaust fumes from the
!
engine are hot and may contain sparks
which can start a fire. Never start the
machine indoors or near combustible
material!
In areas with a hot, dry climate there is a high risk of fires.
These areas are sometimes controlled by legislation and
requirements that among other things the muffler must be
equipped with an approved type of spark arrestor mesh.
For mufflers it is very important that you follow the instructions
on checking, maintaining and servicing your machine.
WARNING! The muffler gets very hot in use
!
and remains so for a short time afterwards.
Do not touch the muffler if it is hot!
• Never use a machine that has a faulty muffler.
• Check that the muffler is securely attached and not
damaged.
Cutting equipment
Make sure the cutter does not hit foreign objects such as
stones, roots or the like. This can make the cutter dull and
bend the engine shaft. Always ensure the cutter is well ground
and balanced correctly. See also instructions under the
heading Maintenance.
Check the cutting attachment. Never use blunt, cracked or
damaged equipment. Damage blades and worn bolts are
major hazards.
Also check that the cutter bolt is undamaged and that the
engine shaft is not bent.
WARNING! Never use a machine with faulty
!
safety equipment. The machine's safety
equipment must be checked and maintained
as described in this section. If your machine
fails any of these checks contact your
service agent to get it repaired.
– 7
English