Simulator; System Status; Self Test; Accessory Test - Humminbird 363 Operation Manual

531448-1_A - 363_Man_Eng.qxd 11/9/2005

Simulator

Use the Simulator to learn how to use your 300
Series TM
the water. The Simulator is a very powerful tool that
simulates on the water operation, providing a
randomly-updated display. We recommend going
through this manual while using the Simulator, since
all of the menus function and affect the display the
way they actually do when in Normal operation.
Simulator
NOTE: To get the full benefit of the Simulator, it is important to select Simulator manually
from the Start-Up Options menu as opposed to letting the 300 Series
Simulator automatically (as it will if a transducer is not connected and you do nothing during
power up). Manually selecting Simulator from the Start-Up Options menu allows you to pre-
configure your 300 Series TM Fishing System for on the water operation. Any menu changes
you make will be saved for later use.
A message will appear on the display periodically to remind you that you are using the
Simulator.
Exit the Simulator by powering your 300 Series

System Status

Use System Status to view system connections and to conduct a unit self-test.
The following screens are displayed in turn when you press the VIEW button when
using System Status:

• Self Test

• Accessory Test

• GPS Diagnostic View.
Exit System Status by powering your Fishing System off.
6:07 PM Page 38
Fishing System before taking your boat on
TM Fishing System enter
TM Fishing System off.
31
Self Test
Self Test displays results from the internal diagnostic
self test, including unit serial number, Printed Circuit
Board (PCB) serial number, software revision, total
hours of operation and the input voltage.
System Status Self Test Screen
Accessory Test
Accessory Test lists the accessories connected to the
system.
NOTE: The speed accessory will be detected only if the
paddlewheel has moved since your 300 Series
System was powered up.
System Status Accessory Test Screen
32
TM Fishing