Table of Contents
Advertisement
Mighty Scan™
REAR PANEL
3
4
2
1
American DJ Supply
- www.americandj.com - Mighty Scan™ Instruction Manual Page 5
©
®
Controls and Functions
5
6
7
Mighty Scan™
1. Dipswitches - These switches serve two functions. In master slave
mode these switches are used to assign a specific head address.
In DMX mode these switches are used to assign a DMX address
to the unit. In DMX mode each switch corresponds to a specific
value based on binary code. See page 10 for detailed explanation
of DMX binary code.
2. Power Cord - Connect only to a matching power outlet. Never use
this fixture is the ground prong has been removed or broken off.
3. XLR Input Jack - This jack is used to accept an incoming DMX
signal or Master/Slave signal.
4. Fuse Holder - This housing stores the 6.3 amp GMA protective
fuse. Always replace with the exact same type fuse, unless other
wise instructed, by an authorized American DJ
5. Microphone - This microphone receives external low frequencies
to trigger the unit in Sound-Active and Master/Slave mode.
6. XLR Output Jack - This jack is used to transmit the incoming
DMX signal to another DMX fixture, or transmit a Master/Slave
signal to the nest Mighty Scan™ in the chain. For best results in
DMX or Master/Slave mode terminate this jack if it is the last unit
in the chain. See "Terminator" on page 12.
7. Audio Sensitivity Knob - This adjust audio sensitivity of the inter
nal microphone. Turning the sensitivity knob in the clockwise
direction will increase the sensitivity to sound. Turning the knob in
the counter clockwise direction will decrease the fixture's sensitiv-
ity to sound.
American DJ Supply
- www.americandj.com - Mighty Scan™ Instruction Manual Page 6
©
®
Controls and Functions
service technician.
®
Advertisement
Table of Contents
