Controls And Functions - American DJ Centurion User Instructions

Centurion™
REAR
1 2
1. Dip Switches -
These switches serve two functions. In master slave mode these
switches are used to assign a specifi c head address. In DMX mode
these switches are used to assign a DMX address to the unit. In DMX
mode each switch corresponds to a specifi c value based on binary
code. See page 7 for a detailed explanation of DMX binary code.
2. IRC/2 Controller Jack -
This is for use the optional IRC/2 Black out controller only. Do not
attempt to connect an audio signal this jack, this will damage the
PC board and void your manufactures warranty!
3. Microphone -
This microphone receives external low frequencies to trigger the unit in
Sound-Active and Master/Slave mode.
4. XLR Input Jack -
This jack is used to accept an incoming DMX signal or Master/Slave
signal.
American DJ - www.americandj.com - Centurion™ Instruction Manual Page 5
© ®

Controls and Functions

3 4 5 6
Centurion™
5. XLR Output Jack -
This jack is used to transmit the incoming DMX signal to another DMX
fi xture, or in master/slave mode transmit a Master/Slave signal to the
next Centurion™ in the chain. For best results in DMX or Master/Slave
mode terminate this jack if it is the last unit in the chain. See "Termina-
tor" on page 11. tor" on page 11.
tor"
6. Cooling Fan -
Keep the fan grill clean. Never block the fan vents, always allow at least
four inches between the fan and any other surface. Improper cooling
may result in premature lamp failure.
7. Fuse Holder -
This housing stores the 5 amp GMA protective fuse. Always replace
with the exact same type fuse, unless otherwise instructed, by an
authorized American DJ
8. Power Cord -
7 8
Connect only to a matching power outlet. Never use this fi xture is the
ground prong has been removed or broken off.
American DJ
©
Controls and Functions
service technician.
®
- www.americandj.com - Centurion™ Instruction Manual Page 6
®