Page 3
User’s Manual K&F ‘SW’ Series Subwoofer Systems Thank you for your decision to buy a Kling & Freitag sound system. To guarantee a trouble-free operating of the equipment and to allow the KLING & FREITAG - sub- woofer system to achieve its full potential please read the operating instructions care- fully before use.
User’s Manual K&F ‘SW’ Series Subwoofer Systems Chapter Page Configurations and Connecting Diagrams Operating the Systems without C2 Controller 9.1.1 ‘XO ON’ Subwoofer with optional Crossover (XO) Operations with C2 Controller 9.2.1 ‘XO OFF’ or Subwoofers without optional Crossover 10. Operating the Speakers 11.
User's Manual K&F ‘SW’ Series Subwoofer Systems 1. General Safety Instructions for Using Speakers Mounting the speakers To prevent injury, the speakers must be securely placed on the floor or secured to the wall according to the instructions on page Fehler! Textmarke nicht definiert. Fehler! Textmarke nicht definiert.
User’s Manual K&F ‘SW’ Series Subwoofer Systems Damage caused by the speakers' magnetic fields Speakers are permanently surrounded by a magnetic field even when they are not oper- ating. Therefore, during transport and placement of the speakers, it is important to ensure that there is always approx.
User's Manual K&F ‘SW’ Series Subwoofer Systems 2.6 SWi 118E Short description: High-performance subwoofer for fixed installations with exponential tunnel geometry, controllable with system controller. Direct-radiating 18" long-excursion chassis, bass reflex tuning. Enclosure: Frame-reinforced Finnish Multiplex enclosure with highly resistant black (RAL 9005) structured paint.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 3. Notes for the ‘Outdoor’ Option Speakers with the option ‘Outdoor Mobile’ and ‘Outdoor Installation’ have been opti- mised for outdoor use. They withstand temperature fluctuations in moderate climate zones and do not accumulate condensation water. In order to guarantee the longevity and safety of the speakers, the speakers with the option ‘Outdoor’...
User's Manual K&F ‘SW’ Series Subwoofer Systems 4. Notes for the SW112 / SWi 112 with Option ‘100V’ Kling & Freitag speakers with ‘100V’ option are fitted with high-quality toroidal trans- formers. This serves to minimize loss of sound. Highly professional sound reinforcement results can be achieved by using 100 V Kling &...
User’s Manual K&F ‘SW’ Series Subwoofer Systems 5. Instructions for Suspending the Speakers The speakers may only be suspended by trained specialised personnel with proof of their qualifications. Observe the prescribed safety factors. Follow the safety instructions for speakers and mounting equipment as well as the respective national rules, norms and safety regulations.
User's Manual K&F ‘SW’ Series Subwoofer Systems 5.2 Subwoofers with ‘Flying Thread’ M12 (SWi Versions) If you want to use the SP subwoofers equipped with ‘flying threads’ M12, please read the following instructions. Appropriate fastening mechanisms with an external screw thread of M12 and a mini- mum length of 35 mm! may be screwed on to the M 12 thread inserts.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 5.3 Subwoofers with ‘allsafe JUNGFALK’ Flying Points Single Stud Fitting ‘allsafe JUNGFALK’ Flying Point Used as fastener to the ‘allsafe Receptacle for special fasteners. JUNGFALK’ flying Point. Take the single stud fitting in one ...
User's Manual K&F ‘SW’ Series Subwoofer Systems 5.4 SW 215E ‘Suspension’: Using the allsafe Flying Track The subwoofer SW 215E with suspension option may only be suspended by using the double stud fittings available from Kling & Freitag. The ‘allsafe JUNGFALK’ flying tracks are used to suspend the SW 215E system.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 6. Mounting Instructions for Speakers Mount the speakers securely. To avoid injury or damage, always be sure to mount the speakers securely so that they do not fall. Speakers, which are stacked, must be secured with securing straps.
User's Manual K&F ‘SW’ Series Subwoofer Systems 6.2 LINE 212 Systems on Top of SW 115E Stapelmulden für SW 115E In addition to the stacking foot Stapelmulden für 'LINE 212' grooves for stacking the same enclosures, the subwoofer SW 115E also has stacking foot grooves for the Line 212 system.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 7. Short Circuit Fuses in the K&F Subwoofer Systems 7.1 Risks of using High Performance Power Amplifiers In recent years, power amplifiers have achieved increasingly higher levels of perform- ance. Some of them can be operated with low-impedance loads. There are, therefore, strong power amplifiers that can reliably work with impedances below 1 Ω.
User's Manual K&F ‘SW’ Series Subwoofer Systems 7.4 Replacement and Positions of the Short Circuit Fuses When the fuse is burned out, then the chassis is most likely already ruined, as the fuse just prevents consequential damage resulting from a short circuit of the chassis. A disassembly of the chassis is, therefore, unavoidable.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 8. Wiring The Speaker is equipped with two parallel-wired Speakon connectors. Before connecting your speaker as shown in chapter 9 be sure to switch off all con- nected appliances and turn down all level controls. −...
User's Manual K&F ‘SW’ Series Subwoofer Systems 8.2 Avoiding Ground Loops 8.2.1 What is a Ground Loop? Every component of a P.A. or Hi-Fi System has its own internal 0V reference (ground). This point is often connected to the protective earth connector (PE / Ground). If two or more units are connected to one another with a line level audio cable, there may be a ground connection through the ground of the power supply cable (yellow-green) as well as through the shielding of the audio cable.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 9. Configurations and Connecting Diagrams 9.1 Operating the Systems without C2 Controller The K&F subwoofers with integrated crossover (SW 112 - XO / SW 115D - XO or SW 118E - XO) can be combined with K&F top speakers by simply connecting them in parallel. 9.1.1 ‘XO ON’...
User's Manual K&F ‘SW’ Series Subwoofer Systems 9.2 Operations with C2 Controller The C2 Controller optimises the operating safety of speakers and power amplifiers through special peak and RMS limiters with sense technology: With other (universal) controllers, the gain of the selected power amplifiers must be known.
User’s Manual K&F ‘SW’ Series Subwoofer Systems 9.2.1 ‘XO OFF’ or Subwoofers without optional Crossover Operations with Controller C2 in 2-way active mode For using Subwoofers with XO, set switch on the back to 'XO OFF' LINK, e.g. to next controller ALL SPEAKONS KLING &...
User's Manual K&F ‘SW’ Series Subwoofer Systems 10. Operating the Speakers − Switch off all equipment and turn down all level controls. − Connect your subwoofers in accordance with preceding connection diagrams. − Please pay attention to the user’s manual of your power amplifier! −...
User’s Manual K&F ‘SW’ Series Subwoofer Systems 13. Technical Specifications 13.1 SW 112 Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 35 Hz -- - 2.5 kHz Frequency range ±3 dB 41 Hz - 350 Hz Crossover frequencies max.
User's Manual K&F ‘SW’ Series Subwoofer Systems 13.2 SWi 112 Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 35 Hz -- - 2.5 kHz Frequency range ±3 dB 41 Hz - 350 Hz Crossover frequencies 110 Hz with optional low-pass filter (XO 'ON') Power handling 500 W nominal...
User’s Manual K&F ‘SW’ Series Subwoofer Systems 13.3 SW 115E Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 37 Hz - 320 Hz Frequency range ±3 dB 43 Hz - 150 Hz Power handling 750 W nominal 1500 W programme Sensitivity 1 W / 1 m 95 dB (37 Hz - 320 Hz)
User's Manual K&F ‘SW’ Series Subwoofer Systems 13.4 SWi 115E Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 37 Hz - 320 Hz Frequency range ±3 dB 43 Hz - 150 Hz Power handling 750 W nominal 1500 W programme Sensitivity 1 W / 1 m 95 dB (37 Hz - 320 Hz)
User’s Manual K&F ‘SW’ Series Subwoofer Systems 13.5 SW 118E Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 30 Hz -- - 2.5 kHz Frequency range ±3 dB 38 Hz - 300 Hz Crossover frequencies 110 Hz with optional low-pass filter (XO 'ON') Power handling 700 W nominal...
User's Manual K&F ‘SW’ Series Subwoofer Systems 13.6 SWi 118E Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 30 Hz -- - 2.5 kHz Frequency range ±3 dB 38 Hz - 300 Hz Crossover frequencies 110 Hz with optional low-pass filter (XO 'ON') Power handling 700 W nominal...
User’s Manual K&F ‘SW’ Series Subwoofer Systems 13.7 SW 215E Speaker Design Bass reflex system with exponential tunnel geometry Frequency range -10 dB 36 Hz - 1 kHz Frequency range ±3 dB 42 Hz - 250 Hz Crossover frequencies max. 200 Hz Power handling 1500 W nominal 3000 W programme...
User’s Manual K&F ‘SW’ Series Subwoofer Systems 16. Regulations for Disposal 16.1 Germany: It is not allowed to dispose of used electrical equipment as domestic waste. But please do not dispose of them at official collecting points for recycling either! All Kling &...