Page 3
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ Thank you for your decision to buy a Kling & Freitag sound system. To guarantee a trouble-free operating of the equipment and to allow the KLING & FREITAG -- - 'SP' speaker system to achieve its full potential please read the operating instructions care- fully before use.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 1. General Safety Instructions CAUTION Risk of electric shock! Do not open the units! Warning: To avoid electric shock hazard, do not expose this appliance to rain or moisture. The enclosures may only be opened by qualified personnel! Do not install devices in any of the following places: where the devices are permanently exposed to direct sunlight.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ Maintenance and Technical Service The user should not perform any maintenance work on the equipment other than that which is described in this manual. Repairs should be executed by a qualified service technician only.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 2. Introduction SP Loudspeakers 'SP' denotes a new option for selected models in the K&F range of loudspeakers. Based on selected K&F speaker systems, the ‘SP’ models are equipped with state-of- the-art integrated driver circuits and Class D power amplifier technology. The ex- tremely lightweight system electronics replace ponderous racks, power amplifiers, controllers, and speaker cables.
Page 9
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ Modes of Operation Operations without external controller: with activated filters (FILTERS ‘ON’), all K&F models in the ‘SP Series’ are combin- able with one another by simply linking the signal from one speaker to the next. With optional K&F system controller*: with system plug-in cards via the K&F Controller C2 or an Audio DSP*: if used with BSS Soundweb, FDS 366, 336, 334, and XTA DP 226, 224, K&F sys-...
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 3. Connectors, Controls und Displays 1) LINE IN and LINE OUT (+6 dB) Electronically balanced input and output connectors. Use the XLR female connector (marked 'IN') as input. The parallel-wired XLR male connector (OUT) is for connec- tions to further 'SP' loudspeakers.
Page 11
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 4) GAIN CONTROL (± 6 dB) a) The gain control can be used to adjust the input level of the amplifier module by ± 6dB. It serves to balance the volume levels of the various systems. In or- der to avoid overloading the input circuit or the mixer’s output circuit, it should normally be set in the case of K&F full-range systems at 0 dB (centre notch setting).
Page 12
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 6) LED POWER ON (GREEN) and LIMIT / PROTECT (RED) The LED is dual-purpose: a) When the LED is green, the speaker is connected to the supply voltage and ready for operation b) The LED will turn red if…...
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 7) AC MAINS 'IN' Connect this PowerCon socket using the mains cable supplied to a max. 16 A fused mains socket, paying particular attention to the stated mains voltage! Connection to an incorrect mains voltage can result in irreparable damage! 8) AC MAINS 'OUT' Important Socket for connection to further equipment such as further speakers with SP mod-...
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 5. Safety Instructions for Suspending the Speakers The speakers may only be mounted by trained specialised personnel with proof of their qualifications as an approved ‘rigger’. Please follow the accompanying instructions for speakers and assembly equipment.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 5.2 SP-Subwoofers with ‘Suspension Thread’ M12 (SWi-Versions) If you want to use the SP subwoofers equipped with ‘suspension threads’ M12, please read the following instructions. Appropriate fastening mechanisms with an external screw thread of M12 and a mini- mum length of 35 mm! may be screwed on to the M 12 thread inserts.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 5.3 Subwoofer SP with ‘allsafe JUNGFALK’ Flying Points Single Stud Fitting ‘allsafe JUNGFALK’ Flying Point Used as fastener to the ‘allsafe Receptacle for special fasteners. JUNGFALK’ flying point. Take the single stud fitting in one ...
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 5.4 SW 215E ‘Suspension’: The ‘allsafe JUNGFALK’ Flying Track The subwoofer SW 215E with rigging option may only be suspended by using the dou- ble stud fittings available from Kling & Freitag. The ‘allsafe JUNGFALK’ flying tracks are used to suspend the SW 215E system.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 6. Mounting Instructions for Speakers Mount the speakers securely. To avoid injury or damage, always be sure to mount the speakers securely so that they do not fall. Speakers, which are stacked, must be secured with securing straps.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 6.2 LINE 212 Systems on Top of SW 115E-SP Stapelmulden für SW 115E In addition to the stacking foot Stapelmulden für 'LINE 212' grooves for stacking the same enclosures, the subwoofer SW 115E -SP also has stacking foot grooves for the Line 212 system.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 7. Wiring Before connecting your SP system, be sure to switch off all connected appliances and turn down all level controls. We recommend the use of high-quality cables provided by KLING & FREITAG. For connections to the line level inputs, please use 2-pin shielded microphone cable with high-quality connectors.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 7.2 Connecting the Power Connectors to the Connecting Terminal Only use the supplied power cable and connect it to a mains outlet with a 16 A fuse. Warning See instructions in chapter 4 'Power Cord' on page 13. 8.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 8.2 Operation with C2 Controller The frequency range of the SP subwoofers with filters switched off (FILTERS 'OFF') is 100% identical to the frequency range of the corresponding K&F speakers without SP module (models without XO).
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 8.3 Maximum Configuration It is possible to use a large number of SP speakers in parallel simultaneously, however this number is limited according to the permitted minimum load impedance of the sig- nal source (e.g.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 9. Operating the Speakers Switch off all equipment and make sure that the SP speakers are not connected to a power source. Connect your SP systems in accordance with preceding connection diagrams. Use only mains cables, which comply with your national safety regulations.
User’s Manual K&F Self Powered Subwoofer Systems ‘SP’ 15. Regulations for Disposal 15.1 Germany: It is not allowed to dispose of used electrical equipment as domestic waste. But please do not dispose of them at official collecting points for recycling either! All Kling &...