Heath Zenith Motion Sensor Light Control SH-5408 Owner's Manual

Motion Sensor
Light Control
Model SH-5408
Meets the ENERGY STAR
when used with 120 W Max bulbs.
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
This package includes:
Lamp Holders
Cover
Sensor
Plate
Light Control
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
• The backplate has knockouts so the sensor can be
mounted on most junction boxes.
• In some applications a universal adaptor plate may
be needed. Adaptors are available at home centers
and electrical supply stores.
© 2008 HeathCo LLC
Mode:
Test
Normal
Manual
Note: When first turned on wait about 1
the circuitry to calibrate.
guidelines
®
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.
Put the ON-TIME switch in the 1, 5,
or 10 minute position.
Manual mode only works at night
because daylight returns the sensor
4 Mounting
to AUTO.
Screws (2 sizes)
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
2 Wire
Manual mode works only with the
Connectors
ON-TIME switch in the 1, 5, or 10
position.
Gasket
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
OPERATION
On-Time:
5 Sec
1, 5, 10 min.
Until Dawn*
* resets to Auto Mode at dawn.
TEST
AUTO
MANUAL MODE
Mode Switching Summary
TEST
AUTO
MANUAL MODE
Works: Day Night
x x
x
x
/ minutes for
1
2
ON-TIME
10 5 1 TEST
ON-TIME
10 5 1 TEST
1 Second OFF
then...
... back on.
Move ON-TIME Switch
to 1, 5, or 10 minutes
Flip light switch
off for one second
then back on*
598-1156-03