Installation - Heath Zenith DualBrite Triple Halogen Motion Sensing Light 5598 Owner's Manual

instaLLatiOn

For best performance, mount the fixture about 6 feet
(1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove X-Bar.
3. Tighten mounting screws on X-Bar finger tight.
4. Attach X-Bar to junction box.
Decorative Nut
X-Bar
Bracket Mounting
Screw
Note: We recommend having an assistant help hold
the lantern assembly during the wiring process.
Lantern
X-Bar
Lantern Mounting
Screw
Junction Box
Warning: turn power off at circuit breaker
or fuse.
Note: All wiring should be run in accordance with the
National Electrical Code through conduit or another
acceptable means. contact a qualified electrician
if there is any question as to the suitability of
the system.
cautiOn: DO nOt connect the reD wire
unless you want to control other lights from
the motion sensor (see Optional Wiring).
One Motion Light
BLACK
WHITE
Two Motion Lights
Connect the fixture wires to the wires in the junction
box. Twist the wires together and secure with wire
connectors.
2
Wiring
BLACK
WHITE
BLACK
WHITE
598-1314-00