Installation - Heath Zenith 598-1041-04 User Manual

INSTALLATION

For best performance, mount the fixture about
1.8 meters above the ground.
❒ Turn power off at the circuit breaker
or fuse.
1. Remove
two nuts.
3. Tighten screws
finger tight.
5. Attach X-Bar to
junction box
Due to the size and weight of the fixture, you
may find it helpful to have an assistant hold
the fixture in place while connecting the wires.
2. Remove
X-Bar.
SENSITIVITY
MIN
MAX
4. Set sensitivity on
fixture back to the
mid-position.
Junction
Box
WIRING
WHITE
One Motion Light
BLACK
WHITE
Two Motion Lights
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green "pigtail". If you are unsure
about the grounding method, consult
your local building code.
CAUTION: If you are not controlling stan-
dard fixtures from your Motion Sensing
Coach Light, DO NOT connect the RED
wire.
Recommended Grounding Method
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the "pigtail"
with the GND screw on the X-Bar.
Black to black
2
BLACK
BLACK
White to white
598-1041-04