Acer AcerPower F2 Service Manual page 72

BIOS Messages
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
IRQ Setting Error
Expansion ROM Allocation Fail
I/O Resource Conflict(s)
Memory Resource Conflict(s)
PCI Device Error
PS/2 Pointing Device Interface Error
PS/2 Pointing Device Error
DMI Table Was Destroyed
Press "DEL" key to enter Setup or F1 key to
continue
Press ESC to turn off NMI, or any key to reboot
Insert system diskette and press ENTER key to
reboot
64
Action/FRU
1. Enter BIOS Setup and load the default settings.
2. Check IDE drive jumper.
3. IDE hard disk drive power.
4. IDE hard disk drive cable/connection.
5. IDE hard disk drive.
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system.
1. Re-connect PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 mouse
4. PS/2 keyboard
5. System board
1. Flash BIOS
1. Press DEL to enter Setup and reconfigure the
system.
1. Press ESC to reject NMI error or press any other
key to reboot the system.
1. Insert a bootable disk into the floppy disk drive
or remove this disk if a hard disk is installed.
Chapter 4