Table of Contents
Advertisement
Available languages
Available languages
Quick Links
Decorative Wireless Chime
This package includes (Style of push button and chime may vary from illustra-
tions):
• Wireless chime
• Wireless push button w/battery
• Hardware pack
You'll need to buy 3 "D" alkaline batteries for the chime. In typical use,
alkaline batteries will last up to three years.
Cover
Mounting
Tabs
© 2007 HeathCo LLC
6180 Series, 6270 Series, and 6280 Series
Figure 1
Chime
Volume
Jumpers
-
-
+
+
+
-
Figure 2
1.
Install alkaline type A23 12
volt push button battery. Re-
move back of case by pushing
in tab on bottom with a small
screwdriver (see Figure 1).
Make sure battery is oriented
properly (See page 4).
2.
Install 3 alkaline "D" batteries.
Make sure batteries are oriented
properly (see Figure 2).
3.
Test range. Temporarily posi-
tion chime and push button
where you want them mounted.
Press push button to verify
chime and push button work
properly. If chime does not
sound, see Troubleshooting.
595-5506-11
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Heath Zenith Decorative Wireless Chime 6180
Summary of Contents for Heath Zenith Decorative Wireless Chime 6180
- Page 1 Decorative Wireless Chime 6180 Series, 6270 Series, and 6280 Series This package includes (Style of push button and chime may vary from illustra- tions): • Wireless chime • Wireless push button w/battery • Hardware pack You'll need to buy 3 "D" alkaline batteries for the chime. In typical use, alkaline batteries will last up to three years.
- Page 2 To mount with screws, remove back of case by pushing in tab on bottom with a small screw- driver. Attach back of case to door jamb or wall. Snap front of push button on. When attaching push button using double sided tape, make sure the surface of the door jamb or wall is clean.
- Page 3 Chime with separate cover and base: The chime base can be mounted in two different ways. The base can be mounted using the keyholes or the three mounting holes. The base may be mounted hori- zontally or vertically depending upon the specific model purchased. Remove batteries from chime.
-
Page 4: Tune Settings
/Zenith wireless push button for a second entrance. We ® recommend the back door use the Ding tune and the front door use the Ding- Dong tune (or Westminster tune, available on selected Heath Models that include two push buttons will come factory set for front and back doors. -
Page 5: Troubleshooting
Chime does not sound: • Make sure push button and chime codes are the same (See pages 3 and 4). • Check orientation of push button battery (See page 4). • Check charge of push button and chime batteries, replace if necessary. Batteries seem OK, but the chime does not work when installed: •... -
Page 6: Limited Warranty
This is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or province to province. For a specified period depending upon model (see chart below) from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to you. - Page 7 Campanilla Decorativa Inalámbrica Serie 6180, Serie 6270 y Serie 6280 Este paquete tiene (El estilo del pulsador y de la campana puede variar de la ilustración): • Campana Inalámbrica • Pulsador inalámbrico con batería • Paquete de ferretería Usted deberá comprar 3 pilas alcalinas “D” para el timbre. Con un uso normal, las pilas alcalinas durarán hasta tres años.
- Page 8 Figura 3 por ambas caras, asegúrese que la superficie de la pared o la del batiente de la puerta estén limpias. Monte la campana. Hay dos maneras diferentes de montar la campana dependiendo del modelo de campana que compró. Determine abajo cuál modelo compró.
- Page 9 Campana con tapa y base separadas La base de la campana puede montarse de dos formas diferentes. Puede montarse usando los agujeros bocallaves o bien los tres orificios de montaje. La base puede montarse horizontal o verticalmente dependiendo del modelo específico comprado.
- Page 10 Su campana inalámbrica Heath seleccionarse: Tilín (una nota), Tilín-Talán (dos notas), o Westminster (ocho notas) (Disponible en los timbres Heath de fábrica es el tono Tilín-talán (o el tono Westminster cuando está disponible). Este tono puede ser cambiado siguiendo las instrucciones que siguen. •...
-
Page 11: Análisis De Averías
Análisis de Averías La campana no suena: • Asegúrese que los códigos del pulsador y de la campana sean los mismos (Vea las páginaciones 9 y 10). • Verifique la posición de la batería del pulsador (Ver página 10). • Revise la carga de las baterías del pulsador y de la campana, reemplácelas si es necesario. -
Page 12: Garantía Limitada
Esta es una “Garantía Limitada” que le da a Ud. derechos legales específicos. Usted puede también tener otros derechos que varían de estado a estado o de provincia a provincia. Por un período específico desde la fecha de compra y dependiendo del modelo (vea el cuadro de abajo) cualquier funcionamiento defectuoso ocasionado por partes o mano de obra defectuosas de fábrica será... - Page 13 Carillon décoratif sans fil Série 6180, Série 6270 et série 6280 Cet emballage contient (Le style de l’unité de bouton-poussoir et du carillon peut varier par rapport à l’illustration): • Carillon dans fil • Unité de bouton-poussoir sans fil, avec pile •...
- Page 14 Figure 3 Lorsque vous montez l’unité de bouton-poussoir en utilisant du ruban adhésif double face, assurez-vous que la surface du montant de porte ou du mur est propre. Installez le carillon. Il existe deux méthodes d’installation distinctes, selon le modèle de carillon. Déterminez d’abord le modèle de carillon acheté, comme indiqué...
- Page 15 Carillon avec socle et couvercle distinct Le socle du carillon peut être installé de deux manières distinctes, soit au moyen des trous piriformes ou des trois orifices d’installation. Il peut en outre être monté à l’horizontale ou à la verticale selon le modèle acheté. Retirez les piles du carillon.
- Page 16 Votre carillon sans fil Heath Ding (une note), Ding-Dong (deux notes) et Westminster (huit notes) (Dis- ponible sur certains modèles de carillon Heath est celui du timbre Ding-Dong (ou l’air Westminster, lorsque disponible). Pour changer cet air réglé à l’usine, suivez les directives ci-dessous. •...
-
Page 17: Dépannage
Le carillon ne sonne pas: • Assurez-vous que les codes de l’unité de bouton-poussoir et du carillon sont identiques (Voir les pages 15 et 16). • Vérifiez l’orientation de la pile de l’unité de bouton-poussoir (Voir page 16). • Vérifiez l’état de charge de la pile de l’unité de bouton-poussoir, et rempla- cez-la si nécessaire. -
Page 18: Garantie Limitée
Il s’agit d’une « Garantie limitée » qui vous confère des droits juridiques spécifiques. Vous pouvez également jouir d’autres droits, variables d’une province à l’autre. Pour une période déterminée, selon le modèle (voir tableau ci-dessous), et à comp- ter de la date de l’achat, toute défectuosité attribuable à des pièces défectueuses à... - Page 19 NOTES / NOTAS / REMARQUES ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ 595-5506-11 -19-...
- Page 20 NOTES / NOTAS / REMARQUES ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ 595-5506-11 -20-...
- Page 21 NOTES / NOTAS / REMARQUES ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ 595-5506-11 -21-...
- Page 22 Chime Purchase Information Información de la compra de la campana Renseignements d’achat du carillon Model #: _______________ Nº de modelo / N° de modèle Staple Purchase Receipt Here Engrape aquí el recibo de compra Agrafez le reçu d’achat ici PLEASE KEEP YOUR DATED SALES RECEIPT, IT IS REQUIRED FOR ALL WARRANTY REQUESTS.
- Page 23 NOTES / NOTAS / REMARQUES ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ ______________________________ 595-5506-11 -23-...
- Page 24 Keyhole Mounting (Vertical) Montaje método orificio bocallave (vertical) Installation au moyen des trous piriformes (à la verticale) UP (Vertical) ARRIBA (vertical) HAUT (à la verticale) Mounting Holes Orificios de montaje Orifices d’installation 595-5506-11 -24-...
Need help?
Do you have a question about the Decorative Wireless Chime 6180 and is the answer not in the manual?
Questions and answers
how to set two door bells to activate two receivers at the same time with the same chime
To set up two Heath Zenith Decorative Wireless Chime 6180 doorbells to activate two receivers simultaneously:
1. Open the cases of both push buttons and both chimes.
2. Locate the jumper settings inside each device.
3. Set jumpers in positions 1 through 7 to be exactly the same on both push buttons and both chimes. This ensures all devices share the same communication code.
4. Choose a tune by setting jumper position 8 (add jumper for chime, remove for push button).
5. Install A23 12V batteries in the push buttons with correct orientation.
6. Mount the push buttons and chimes as needed.
7. Test by pressing a push button; both chimes should sound.
This configuration causes both receivers to respond to either push button.
This answer is automatically generated