Installation; Select The Best Location - LG Room Air conditioner Owner's Manual

Installation Instructions
Read completely, then follow stepoby step.
• The appliance shall be installed in accordance with national wiring regulation.
• If a power plug isn't to be used, provide a circuit breaker be_een power _urce and the unit, as following
picture.
Select the Best Location
Power sou roe
Breaker
Use a cJrcuit breaker
or time _lay.
Note: Use 20A circu_ breaker for 22K,
24K Btu/h Models
@
@
To prevent vibration and noise, make sure
the unit is installed securely and firmly.
Instaii the unit where the sunlight does not
shine directly on the unit.
FOAM ......
COOLED
There should be no obstacle, such as a
fence or wall, within 50cm from the back of
the cabinet because it will prevent heat
radiation of the condenser.
Restriction of outside air will greatly reduce
the cooling efficiency of the, air conditioner.
Instaii the unit a little obliquely outward not to
leak the condensed water into the room
(about 10 ~ 15mm or 1/4 bubble with leveO.
CAUTION: All side louvers of the cabinet must
remain exposed to the outside of
the structure.
FENCE
AWNING
HEAT
RADIATION
!O-15mm
Over 50cm
1/4 Bubble
Remove the Air Conditioner From the Case
[_] Remove the 2 shipping _rews from the
back of the case.
Remove the 2 screws on each side of the
case. Keep these for later use.
_ Slide the air conditioner from the case, by
gripping the base pan handle and pulling
forward while bracing the case
Shipping screws