Install The Air Conditioner In The Case - LG Room Air conditioner Owner's Manual

Install the Air Conditioner in the Case
_ Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on
each side of the case.
[_ Attach the front grille to the case by
inserting the tabs on the grille into the slots
on the front of the case. Push the grille in
until it snaps into place,
Screw
Power Cord
CAUTION: Thepower cord must be connected to
an independent circuit.
Thegreen wire must be grounded,
Stuff the foam between the top of the unit
and the wall to prevent air and insects from
geeing into the room.
The Foam
Before installing the front grille, pull out the
vent control lever located above the unit
control knobs, as shown.
,i r
r"
When you detach the
front grille from the
case, push the grille
to your rightside and
pull it toward you.
Lift the inlet grilll and secure the front gdlle
with a screw. Lower the inlet gdlle into
piace.
Use the Reversible Inlet Grille
_lf want to pull out the filter upward, the inlet grille slightly.
you open
Turn inside out the front grille.
Disassemble the inlet grille from the front grille with separating the
hinged pa_ by inse_ing a .... type screw-driver tip.
Rotate the inlet grille 180 degrees and insert the hooks into the
lower holes of front grille,
Then, insert the filter
[_ If you want to pull out the filter downward, use the reversible inlet
grille without change.(The grille is already assembled for that way.)