Removing A Filled Bag; Compactor Care - Kenmore 665.1363 Series Use & Care Manual

COMPACTOR CARE
Your new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do
in order to propedy maintain your compactor. This section will tell you how to clean and care for your compactor.
Cl ing
Before cleaning the compactor, turn the Key-Knob (or Key-
Switch) to the OFF & LOCK position end remove it.
NOTE: Any services other than those outlined in this section
should be performed by a designated service representative.
Cleaning Exterior Surfaces
1. Wash extedor surfaces 0ncluding stainlesssteel) with a clean
sponge or soft cloth end a mild detergent in warm water. Do
not use abrasive or harsh cleaneR. Rinse and dry thoroughly
with a soft cloth.
2. Wipe up spills right away. Some foods can damage the finish
if left on the compactor surface,
Cleaning Inside the Drawer
NOTE: You may want to wear protective gloves since there may
be bits of glass in the drawer.
1. Remove the bag. Son the "Removing a Filled Bag."
2. Press down on the lever-action look (or Side-Lock latch).
Cleaning In,de the Cabinet
NOTE; You may want to wear protective gloves since there may
be bits of glass in the cabinet.
1. Pullthe drawer out until if stops.
NOTE; Look to see how the drawer rollersmove in the tracks.
It will be easier to replace the drawer after you have finished
cleaning.
2. Lift the front of the drawer to clear the stops.
3. Grasp the drawer on the sides and pull it out the rest of the
way. Set the drawer down gently.
3. Hold the lever-action lock down and tilt the side of the drawer
out until the lock clears the drawer front.
NOTE; If dasired, the drawer side can be removed by tilting it
up, than liftir_ it out.
4. Vacuum the inside of the cabinet. Uquid spillsor wst trash
should be cleaned up by hand, or by usinga vacuum
designed to i_ck up liquids.
===m_=
4. Wash the intedor of the drawer with a clean sponge or soft
cloth and a mild detergent in warm water, Rinse and dry
thoroughly with a soft cloth.
5. if the drawer side was removed, slide it back into the tilted
position.
6. Press the lever-action lock (or Side-Lock Latch) down while
pushing the drawer side to the upright position.
7. Latch the drawer side by pushing up the lever-action look (or
Side-Lock Latch).
5. Wash the inside of the cabinet with a clean sponge or soft
cloth end a mild detergent in warm water. Rinse and dry
thoroughly with a soft cloth.
6. To replace the drawer, grasp it by the sides and insert the
rollersonto the tracks.
7. Lift the front of the drawer and push it in fuel,/past the stops.
Cleaning the Ram
NOTE: You may want to wear protective g|oves since there may
be bits of glass on the ram cover.
1. Wipe glass particles off of the ram cover with a cloth or paper
towels.
11