Installinga New Bag - Kenmore 665.1363 Series Use & Care Manual

2. You may almedy have a paper or plastic bag in place. Please
refer to appropriate instructionsfor your bag.
• If you have a paper bag, lift and fold up the top folded
edges of the bag. Fold ends in and bring side flaps
together. Fold flaps to close bag.
Liftandfoldup topbagedges. Foldends toclosebag.
• If you have a plastic bag, remove top of bag from bag
retainer buttons. Close bag with a twist tie.
Remove bag from retainer buttons. Close bag with twist tie.
3. Release drawer side latch. _lt right drawer side down. This
will make removing the full bag easier.
4. Lift bag by bag caddy handles. Remove _ash bag from
compactor and dispose properly.
NOTE: Fully compacted trash bags will be heavy. Handle with
care,
A. Liftingbag caddybyhandles
Do not use any kind of bag other than those designed especially
for use in your compactor. Order replacement compactor bags
through your localdealer. See "Accessories."
IMPORTANT:
Before installinga new bag, be sure:
• The drawer side is securely locked.
•
The container is clean and free of debris.
To install a new bag
1. Close drawer side. Lock drawer side latch.
2. Put bag caddy into drawer.
A. Bag caddyinsidedrawer
3. Place either a plastic or paper bag into the drawer.
• If using a paper bag, open bag and pull top edges over
the drawer top. Slide front edge of bag over front edge of
drawer. Slide rear edge over rear of drawer.
• If using plastic bag, open bag and pull top edges over
drawer top. Lock bag into place by pullingthe
4 prepunched holes over the bag retainer buttons. Holes
will expand over buttons without harming bag.
Installing paperbag Installing plasticbag
4. Pmas inside of bag against the drawer bottom, sides and
corners for a smooth fit.
10