Kenmore 796.2947 Series Use & Care Manual page 37

BEFORE CALLING FOR SERVICE (continued)
!! i ii i i i iiiii i i ii!iiiiiiiiiii!i!! !iii!!!ii!iiiii!!i ! !! !ii
Water leaks every load.
LCD Screen is dim.
Touch screen does not
respond or the wrong
icons are selected.
Touch screen is blank,
and the POWER button
is llt.
The washer wlll not
operate, but the dlsplay
works normally.
Hoses not installed correctly.
Normal screen dimming.
Screen Brightness is set too low.
Touch screen needs to be
calibrated.
Touch Screen needs to be reset.
Touch Screen needs to be reset.
Washer is in Demo mode with
Demo icon displayed.
iiiiiiiiiiiiiiiiiiiill iii iiiiiiiiiiiiiii iiiiiiiiiiiiiiiii ii!ii iiiiiiiiiiiiiiii iii ii iii_!_iiiii]iiii iiii!iiii_ii!
Check all flit and drain hose connections to ensure that
they are tight and secure.
This is normal. The screen dims after four minutes of
inactivity. Touch the screen to bring it back to your regular
brightness setting.
Adjust the screen to a brighter setting on the System Settings
screen (refer to page 26).
Touch the Touch Screen Calibration button on the Systems
Settings screen and touch each target as it is displayed (refer
to page 26).
Unptug the washer for 60 seconds. Plug the washer in and
wait 30 seconds. Press the POWER button to turn on the
washer. If the touch screen still does not respond, call for
service.
Unptug the washer for 60 seconds. Plug the washer in and
wait 30 seconds. Press the POWER button to turn on the
washer. If the touch screen still does not respond, call for
service.
Press the POWER button to turn the washer ON. Touch and
hold the Kenmore Etite logo on the power up screen for one
second to turn off the demo mode. Press the POWER button
for normat operation.
If the Demo icon is not present, unptug the washer for 60
seconds. If the washer still will not operate, call for service.
37