Regular Cleaning; Leave The Lid Open; Cleaning The Exterior; Care And Cleaning Of The Interior - Kenmore 796.2947 Series Use & Care Manual

WARNING: Toreduce t heriskofnre, e lectrlc s hock, oriniurv t opersons, reod ondfollowthis
entire Use & Care Guide, inciudlng the important Safety instructions, before operating this washer.
* Unplug the washer before cleonlncj to ovoid the risk of electric shock. Failure to follow this warning can
cause serious injury, fire, electric shock, or death.
* Never use harsh chemlcols, obroslve cleaners, or solvents to cleon the washer. They will damage the finish.
REGULAR CLEANING
Cleaning the Exterior
Proper care of your washer can extend its life. The outside of
the machine can be cleaned with warm water and a mild,
nonabrasive household detergent.
Immediately wipe off any spills with a soft, damp cloth.
IMPORTANT: Do not use solvents, cleaning alcohols, or
similar products. Never use steel wool or abrasive cleaners
because they can damage the surface.
Care and Cleaning of the interior
Use a towel or soft cloth to wipe around the washer lid
opening and lid glass.
Always remove items from the washer as soon as the cycle
is complete. Leaving damp items in the washer can cause
wrinkling, color transfer, and odor. Run the CLEAN WASHER
cycle once a month, or more often if needed, to remove
detergent buildup and other residue.
Clean Washer Cycle
O Remove any clothing in the tub.
O Add liquid chlorine bleach or another tub cleaner
designed specifically for cleaning washers.
- if using llquld chlorlne bleach
Add liquid chlorine bleach to the bleach
compartment.
NOTE= Add one cup of liquid bleach. Do not exceed the
maximum fill line and do not pour undiluted liquid bleach
directly into the tub.
- if using powdered cleaners
Remove the liquid detergent cup and add powder
cleaner to the main wash compartment of the
dispenser drawer.
- if using o tablet cleaner
Put the tablet directly into the tub.
NOTE:
* Do not add tablet cleaner to the
dispenser drawer.
* Do not add any laundry detergent or fabric softener to
the dispenser drawer when using CLEAN WASHER.
Storing the Washer
If the washer will not be used for an extended period of time
and is in an area that could be exposed to freezing
temperatures, perform the following steps to protect the
washer from damage.
Turn OFF the water supply.
Disconnect hoses from water supply and drain water from
hoses.
Plug the power cord into a properly grounded
electrical outlet.
Add 1 gallon of nontoxic recreational vehicle (RV) antifreeze
to the empty tub and close the lid. NEVER use
automotive antifreeze.
Pressthe POWER button, then touch the Drain & Spin
button. Touch the START button to activate
the drain pump. Allow the drain pump to run for one
minute, then press the POWER button to shut off the
washer. This will expel some of the antifreeze, leaving
enough to protect the washer from damage.
O Unplug the power cord, dry the tub interior with a soft
cloth, and close the lid.
Remove the inserts from the dispenser. Drain any
water in the compartments and let them dry.
Store the washer in an upright position.
To remove the antifreeze from the washer after storage,
run a complete EXPRESSWASH cycle using
detergent. Do not add laundry to this cycle.
Removing Mineral Buildup
If you live in an area with hard water, mineral scale can
form on internal components of the washer. Use of a
water softener is recommended in areas with hard water.
Use a descaler, such as Washer Magic ®, to remove
visible mineral buildup. After descaling, always run the
CLEAN WASHER cycle before washing clothing.
Mineral scale and other spots may be removed from the
stainless steel tub using a stainless steel cleaner. Do NOT
use steel wool or abrasive cleaners.
Close the lid and press the POWER button to turn the
washer ON. Touch the left arrow until the CLEAN WASHER
cycle is visible on the screen, then touch the STARTbutton
to begin the cycle. Selecting any other cycle after CLEAN
WASHER has been selected will cause the CLEAN
WASHER cycle to be cancelled.
LEAVE THE LID OPEN
If the washer will not be used for several days, leave the
lid open overnight to allow the tub to dry.
After the cycle ends, open the lid and allow the tub
interior to dry completely.
NOTE: Run the CLEAN WASHER cycle once a month. If a
mildewy or musty smell is present, run the clean washer
cycle once a week for three consecutive weeks.
29