GE JBS05 Owner's Manual page 24

Using the self-cleaning oven.con some mode s
The oven door must he closed and all controls set correctly for the cycle to work properly.
How to Delay the Start of Cleaning
You can set the oven control to delay-start the
oven, clean for a specific length of time and then
turn off automatically.
Make sure the clock shows the correct time
of day.
Follow the directions in the Beforea CleanCycle
section.
r_ Latch the door.
NOTE:Never force the latch. If the oven is too
hot, you will not be able to slidethe latch. Allow
the oven to cool.
[] Touch the SELFCLEAN pad.
r_ Touch the + or - pads to set the Clean
Time.
TheClean Time is preset for 4 hours and 20
minutes. You can change the CleanTime to any
time between 5 and 5 hours, depending on the
amount of soil in your oven. Ira different Clean
Time is desired, touch the + or - pads until the
desiredClean Time is displayed.
Change the Start Time by touching the + or -
pads. Thestart time will appear in the display.
[] Touch the START/ON pad.
The self-clean cycle will automatically begin at
the time set.
While the oven is self-cleaning, you can touch
the CLOCKpad to display the time of day. To
return to the clean countdown, touch the SELF
CLEAN pad.
The oven shuts off automatically when the
clean cycle is complete, and 0".00will flash in
the display.
r6] Slide the latch handle to the left as far as it
will go and open the door.
r_ Touch the START TIME pad.
To Stop a Clean Cycle
Touch the CLEAR/OFF pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door. You
will not be able to open the door right away
unless the oven has cooled below the locking
temperature.
24
After a Clean Cycle
You cannot set the oven for cooking until
the oven is cool enough for the door to be
unlatched.
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.
If white spots remain, remove them with a
soap-filled steel-wool pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
You cannot set the oven for cooking until the
oven is cool enough for the door to unlock.
While the oven is self-cleaning,you can touch
the CLOCKpad to display the time of day.To
return to the clean countdown, touch the SELF
CLEANpad.
If the racks become hard to slide, apply a
small amount of vegetable oil or cooking oil
to a paper towel and wipe the edges of the
oven racks with the paper towel.