GE SmartHome Remote Manual page 12

11
from the old primary remote. The source remote then transfers the network
and device information to the new primary remote. Refer to the user manual
for the new primary remote for more information.
5. When the green LED blinks twice, you have successfully transferred the
information.
6. The source remote is converted into a secondary remote and can not be used
to add or delete devices from the network.
7. Add devices, groups, and scenes to the new primary remote as needed.
NOTE: If the red LED emits one long, steady blink, the information has not been successfully
transferred. Repeat steps 1-6 if this occurs.
Transferring Only Network Information
1. Place the two remotes near each other.
2. Press and hold SETUP until both the red and green LEDs blink twice.
3. Enter 9 6 8 2 on the numeric keypad.
4. Put the target (new primary) remote into programming mode so that it sends its
information to the source (old primary) remote, as well as receive information
from the old primary remote. The source remote then transfers the network
information to the new primary remote. Refer to the user manual for the new
primary remote for more information.
5. When the green LED blinks twice, you have successfully transferred the
information.
6. The source remote is converted into a secondary remote and can not be used
to add or delete devices from the network.
7. Add devices, groups, and scenes to the new primary remote as needed.
NOTE: If the red LED emits one long, steady blink, the information has not been successfully
transferred. Repeat steps 1-6 if this occurs.
COPYING NETWORK AND/OR DEVICE INFORMATION TO THIS REMOTE
This allows a second remote to receive information from the first remote and to
become a new primary or secondary remote.